FARGO electronic HDP5000 manual Adjusting the Lamination Placement on the Card

RESTRICTED USE ONLY Fargo Electronics, Inc.

Adjusting the Lamination Placement on the Card

The Card Lamination Module provides an adjustable Lamination Placement knob that allows you to fine-tune where the lamination is being placed on the card.

Step Procedure

1See Display A (below).

•The Lamination Placement Adjustment Knob is the light gray knob to the right of the Lamination Cartridges.

•The printer will have one or two film cartridges loaded (depending on whether this is a Single or Dual-Side Lamination Module).

2Print a test card to see if the Lamination needs to be adjusted.

•Turn the knob to the right (the negative sign) to move the patch toward the front edge of the Lamination Module. Turn the knob to the left (the positive sign) to move the patch toward the back edge of the lamination module.

•Refer to the instruction diagram label located on the open front cover to make this adjustment. See Display B (below).

Display A – See Procedural Step 1 (above)

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 7-8