FARGO electronic HDP5000 manual Selecting the Lamination Position, Step

RESTRICTED USE ONLY Fargo Electronics, Inc.

Selecting the Lamination Position

Step Procedure

1Use the Lamination Position control to adjust the horizontal position of the PolyGuard Overlaminate. (Note: This control functions in the same manner as the Image Position controls, except only the horizontal position of the overlaminate requires adjustment.)

•To adjust the Lamination position, click on the Horizontal adjustment arrows.

•To move the overlaminate more toward the card output side of the Printer, enter a positive number.

•To move the overlaminate more toward the card input side of the Printer, enter a negative number. (Note: The adjustment arrows point in the direction the patch will move on the card. The maximum value for the Horizontal adjustment is ±100 Pixels (10 Pixels = about .03/.8mm) The default is 0.)

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 8-81