FARGO electronic HDP5000 manual Choosing a Good Location, About Moisture Condensation

RESTRICTED USE ONLY Fargo Electronics, Inc.

Choosing a Good Location

Follow these guidelines:

•Place the unit in a location with adequate air circulation to prevent internal heat build-up.

•Use the Printer's dimensions as a guideline for the minimum clearances to the unit.

(Note: Allow for adequate clearance above the unit to accommodate the height of the unit with its Covers open.)

•Do not install unit near heat sources such as radiators or air ducts or in a place subject to direct sunlight, excessive dust, mechanical vibration or shock.

About Moisture Condensation

If the unit is brought directly from a cold to a warm location or is placed in a very damp room, moisture may condense inside the unit. Should this occur, print quality may not be optimum.

Leave the unit turned OFF in a warm, dry room for several hours before using. This will allow the moisture to evaporate.

Caution: For safety purposes, Ethernet is not intended for a direct connection outside of the building.

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 3-5