FARGO electronic HDP5000 manual Symbol as shown to the left, Grounded to avoid potential damage

RESTRICTED USE ONLY Fargo Electronics, Inc.

Section 3: Installation Procedures

Safety Messages (review carefully)

Symbol	Critical Procedures for Safety purposes
Danger:	Failure to follow these installation guidelines can result in death or
	serious injury.
	Information that raises potential safety issues is indicated by a warning
	symbol (as shown to the left).
	• To prevent personal injury, refer to the following safety messages
	before performing an operation preceded by this symbol.
	• To prevent personal injury, always remove the power cord prior to
	performing repair procedures, unless otherwise specified.
Caution:	This device is electrostatically sensitive. It may be damaged if
	exposed to static electricity discharges.
	Information that raises potential electrostatic safety issues is indicated by
	a warning symbol (as shown to the left).
	• To prevent equipment or media damage, refer to the following
	safety messages before performing an operation preceded by this
	symbol.
	• To prevent equipment or media damage, observe all established
	Electrostatic Discharge (ESD) procedures while handling cables in or
	near the Circuit Board and Printhead Assemblies.
	• To prevent equipment or media damage, always wear an
	appropriate personal grounding device (e.g., a high quality wrist strap
	grounded to avoid potential damage).
	• To prevent equipment or media damage, always remove the
	Ribbon and Cards from the Printer before making any repairs, unless
	otherwise specified.
	• To prevent equipment or media damage, take jewelry off of fingers
	and hands, as well as thoroughly clean hands to remove oil and
	debris before working on the Printer.

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 3-1