FARGO electronic HDP5000 manual Troubleshooting with the Printer Error Message Table

RESTRICTED USE ONLY Fargo Electronics, Inc.

Troubleshooting with the Printer Error Message Table (continued)

Printer Error	Cause	Solution
Message
Laminator Film	A Film break/jam has	The printer has determined that one
Break/Jam	been detected inside the	or both overlaminate films have
	Laminator.	either jammed or broken.
		a. Open the Laminator Cover and
		remove the Laminator
		Cartridge(s). If overlaminate is
		jammed, remove jam and tighten
		the material
		b. Clear any cards in the printer by
		using the Forward and/or Back
		buttons located on the Printer's
		LCD display.
		c. Tape the ends of the
		overlaminate together and wind
		any excess onto the Take-up
		Spool of the Overlaminate.
		d. Re-install the Laminator
		Cartridge(s), close the Laminator
		Cover and press the Resume
		button located on the Printer's
		LCD display to continue printing.
		e. To cancel the print, press the
		Cancel Print button from the
		Driver's display dialog and the
		Cancel button located on the
		Printer's LCD display.
Laminator Film	The Laminator cannot find	Check that the Film is installed
Sensor Error	the next panel on the	properly and press Resume.
	Film.	To cancel, press the Cancel Print
		button or the Cancel button located
		on the Printer.
Remove Laminator	To continue, remove the	Open the Laminator's Front Cover.
Film	laminator's film.	Remove the film and close the
		Laminator's Front Cover.

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 5-34