FARGO electronic HDP5000 manual Restoring the Factory Settings for Ethernet

RESTRICTED USE ONLY Fargo Electronics, Inc.

Restoring the Factory Settings for Ethernet

There may be times when you are unable to use the current configuration of the Ethernet interface. (Note: This could be because you have lost the password for your Printer or you just cannot get it to work properly.)

Resetting the HDP5000 settings

The HDP5000 has a menu selection that allows the User names and passwords to revert to default. To reset these settings, select:

Menu: Setup Printer : Network Settings : Reset Passwords.

Changing the HDP5000 LCD Network Settings

The HDP5000 Printer/encoder will display new menu entries when (a) the Ethernet option is installed and (b) the Printer has established communications to a host device.

•You can use these procedures to change network settings by using the new LCD menus.

Accessing the Network Setup Menu

Step	Procedure
1	Apply power to the Printer.
2	Ensure that the Printer is connected to your network.
3	Wait up to one (1) minute to allow the Printer to configure the IP address.
4	Select Options on the LCD.
5	Select Menu on the LCD.
6	Select the Next button on the LCD until the Network Settings menu entry
	appears.
7	Press Select when Network Settings appears on the LCD.

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 6-50