FARGO electronic HDP5000 Cord is properly connected, cycle, Power and press the Resume, Continue

RESTRICTED USE ONLY Fargo Electronics, Inc.

Troubleshooting with the Printer Error Message Table (continued)

Printer Error	Cause	Solution
Message
Laminator (General	The Laminator has	Press the Resume button located
Error)	reported a general fault.	on the Printer to continue.
		To cancel, press the Cancel Print
		button or the Cancel button located
		on the Printer.
Laminator (Check	The Laminator's power is	Ensure that the laminator's power
Power)	OFF.	cord is properly connected, cycle
		power and press the Resume
		button to continue.
		To cancel, press the Cancel Print
		button or the Cancel button located
		on the Printer.
Laminator (Heater	The Laminator's Heater is	Press the Resume button to
Off)	OFF.	continue.
		To cancel, press the Cancel Print
		button or the Cancel button located
		on the Printer.
Laminator (Heater	The Laminator cannot	a. Reboot the Printer by cycling
Timed Out)	reach the desired	power. Check the Laminator
	operating temperature.	settings in the Printer Driver.
		b. Click on the Default button
		located on the Lamination Tab
		of the driver to set the Laminator
		settings to the factory default.
		c. Resend the print job.
		d. To cancel, press the Cancel
		Print button or the Cancel
		button located on the Printer.

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 5-32