FARGO electronic HDP5000 manual Card Lamination Module

RESTRICTED USE ONLYFargo Electronics, Inc.

Changing to the Static IP Address Mode ______________________________________________ 6-20

Using the Clear Changes button _____________________________________________________ 6-22

Using the Media Information page _____________________________________________________ 6-23

Using the TCP/IP page ______________________________________________________________ 6-24

Using the TCP/IP page ____________________________________________________________ 6-25

Using the Printer page _______________________________________________________________ 6-26

Using the System Log page___________________________________________________________ 6-28

Changing the Log Name___________________________________________________________ 6-29

Selecting the Log Type____________________________________________________________ 6-30

Selecting the Log Destination_______________________________________________________ 6-31

Setting up Email Event logging _____________________________________________________ 6-32

Specifying UDP Event logging _____________________________________________________ 6-33

Specifying TCP Event logging ______________________________________________________ 6-35

Using the Administration pages _______________________________________________________ 6-37

Using the System Information page __________________________________________________ 6-37

Changing the Root Password _______________________________________________________ 6-39

Using the Reboot pages______________________________________________________________ 6-40

Rebooting the Printer _____________________________________________________________ 6-40

Upgrading the Main Firmware ______________________________________________________ 6-41

Using the Print Path page ____________________________________________________________ 6-45

Using the Help page ______________________________________________________________ 6-47

Additional Procedures ________________________________________________________6-47

Accessing the Ethernet Status LEDs ____________________________________________________ 6-47

Reviewing the HDP5000 LED Table _________________________________________________ 6-47

Upgrading the Main Firmware with the Fargo Workbench Printer Utility _______________________ 6-48

Restoring the Factory Settings for Ethernet ______________________________________________ 6-50

Resetting the HDP5000 settings _____________________________________________________ 6-50

Changing the HDP5000 LCD Network Settings ________________________________________ 6-50

Accessing the Network Setup Menu__________________________________________________ 6-50

Changing the DHCP Setting________________________________________________________ 6-51

Changing the ANEG setting ________________________________________________________ 6-51

Saving addresses_________________________________________________________________ 6-52

Resetting Passwords ______________________________________________________________ 6-52

Accessing the HDP5000 IP Address _________________________________________________ 6-53

Ethernet Printer Troubleshooting Procedures _____________________________________6-54

Troubleshooting procedures ________________________________________________________ 6-54

Verifying the Printer Connection ____________________________________________________ 6-55

Verifying the Printer IP address _____________________________________________________ 6-55

Verifying that your PC can access the Printer using the ping command ______________________ 6-56

Printing a test page _______________________________________________________________ 6-57

Reviewing Frequently-asked Questions __________________________________________6-58

Glossary of Terms ____________________________________________________________6-65

Section 7: Card Lamination Module __________________________________________ 7-1

Safety Messages (review carefully)______________________________________________________ 7-2

Reviewing the Card Lamination Module _________________________________________________ 7-3

Installing the Card Lamination Module___________________________________________________ 7-4

Introduction _____________________________________________________________________ 7-4

Inspecting the Card Lamination Module _______________________________________________ 7-5

Unpacking the Card Lamination Module _______________________________________________ 7-5

Choosing a proper Location _________________________________________________________ 7-5

Preventing Moisture Condensation____________________________________________________ 7-5

Installing the Lamination Module Accessory ____________________________________________ 7-6

Adjusting the Lamination Placement on the Card___________________________________________ 7-8

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) v