FARGO electronic HDP5000 manual Troubleshooting with the LCD Error Message Table

RESTRICTED USE ONLY Fargo Electronics, Inc.

Troubleshooting with the LCD Error Message Table (continued)

LCD Error Message	Cause	Solution
Lam Handler Startup	After powering up the	Check Laminator power and
Error	Printer, the Laminator was	connections and restart the
(PC Error Message	detected, but an error	Printer.
	occurred which would
No. 141)
	prevent its use.
Lam Internal Error	A generic unknown error as	Check Laminator power and
(PC Error Message	occurred in the Laminator.	connections and restart the
		Printer.
No. 48)
Lam No Film	There is no material loaded	Load Laminator material.
(PC Error Message	in the Laminator.
No. 157)
Lam Timeout	The Printer timed out while	Check Lam power/connections
(PC Error Message	processing information	and restart the Printer.
	related to the Laminator.
No. 247)
Lam1 Wrong Film	Material in Cartridge 1 of the	Make sure Driver material
(PC Error Message	Laminator does not match	matches what is actually in the
	the material type specified	Laminator.
No. 233)
	by the job.
Lam2 Wrong Film	Material in Cartridge 2 of the	Make sure Driver material
(PC Error Message	Laminator does not match	matches what is actually in the
	the material type specified	Laminator.
No. 234)
	by the job.
Laminate 1 Bad	The Lamination material in	Install valid material.
(PC Error Message	Cartridge 1 is not valid for
	this Laminator.
No. 259 and 261)

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 5-13