FARGO electronic HDP5000 manual Printer Components Transfer Roller

RESTRICTED USE ONLY Fargo Electronics, Inc.

Printer Components: Transfer Roller

Danger: The Printer’s Transfer Roller can reach temperatures exceeding 350 degree F (175 C). Use extreme caution when operating the Transfer Roller. Never touch the Transfer Roller unless the Printer Power has been turned off for at least 20 to 30 minutes.

Type	Description
Controls	Both the Printer itself and the Printer’s software Driver control the
	built-in Transfer Roller.
Temperature	To change the temperature of the Transfer Roller, adjust its
Adjustment	temperature through the Image Transfer Tab within the Printer Driver
	setup window.
	Once adjusted, the new temperature settings will be sent down with
	the next print job along with the rest of the Printer Driver information.
New	Before printing begins, the Transfer Roller will automatically adjust
Temperature	itself to the new temperature setting. (Note: This new temperature
Setting	setting will remain programmed within the Printer until it is once again
	changed within the Printer Driver or until the Printer is turned OFF.)
	Whenever the Printer is turned OFF, the Transfer Roller will
	automatically reset itself and return to its default temperature the next
	time the Printer is turned ON.
	Disconnect the Printer's power supply. (Technician Note: Cycling
	the Printer’s power supply serves to reset the Transfer Roller to its
	default temperature. The temperature setting within the Printer Driver,
	however, will stay the same until it is changed.)

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 2-25