FARGO electronic HDP5000 manual Troubleshooting with the LCD Error Message Table

RESTRICTED USE ONLY Fargo Electronics, Inc.

Troubleshooting with the LCD Error Message Table (continued)

LCD Error Message	Cause	Solution
Empty Reject Bin	The reject bin is full.	Remove the large number of
(PC Error Message		rejected cards from the reject
		bin.
No. 265)
		Click OK to clear the
		notification message. (Note:
		In some cases, rejected cards
		are incomplete or pose a
		security risk, and should be
		disposed of properly.)
Failed To Initialize	A problem was detected	Reset the Printer and try
(PC Error Message	during Printer start-up.	again. If this problem persists,
		call for technical assistance.
No. 141)
Film Align Error	The film is not able to move	Check for obstruction. If the
(PC Error Message	correctly. Check for	problem persists, call for
	jams/breaks.	technical assistance.
Nos. 26 and 176)
Film Break/Jam	The film is not able to move	Check for obstruction. If the
(PC Error Message	correctly. Check for	problem persists, call for
	jams/breaks.	technical assistance.
No. 158)
Film Low	The HDP film will soon run	If printing a large number of
(PC Error Message	out.	cards, replace the Film now or
		monitor the Printer until the
No. 156)
		Film is gone and install a new
		Film.
Film Out	The HDP film has run out.	Install a new roll of film and
(PC Error Message		press Resume to continue or
		Cancel to reset.
Nos. 156 and 157)

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 5-8