Adder Technology CATxIP 1000 manual Global user IP network port, AdderView CATxIP Front panel

Global user (IP network port)

The AdderView CATxIP 1000 models provide an autosensing Ethernet IP port that can operate at 10 or 100Mbps, according to the network speed. The AdderView CATxIP 1000 models are designed to reside quite easily at any part of your network:

•They can be placed within the local network, behind any firewall/router connections to the Internet, or

LOCAL GLOBAL

USER USER

IP

POWER

IN

CAM

COMPUTER POWER

SYSTEM SWITCH

To connect the Global user (IP network) port

1Depending upon where in the network the AdderView CATxIP 1000 is being connected, run a category 5, 5e or 6 link cable from the appropriate hub or router to the AdderView CATxIP 1000 unit.

2Connect the plug of the link cable into the IP port on the front panel of the AdderView CATxIP 1000 unit.

AdderView CATxIP

1000 front panel



•They can be placed externally to the local

network, on a separate sub-network or with an open Internet connection.

Wherever in the network an AdderView CATxIP 1000 is situated, you will need to determine certain configuration issues such as address allocation and/or firewall adjustment to allow correct operation. Please refer to Networking issues within the Configuration chapter for more details.

IMPORTANT: When an AdderView CATxIP 1000 is accessible from the public Internet or dial up connection, you must ensure that sufficient security measures are employed.

Category 5, 5e or 6 cable from Adder X100/X200 module

3Configure the network settings as appropriate to the position of the AdderView CATxIP 1000 within the network - see Networking issues for details.

  



10