3Com Router 5000/6000 Family | 151 |
Command Reference |
|
tracert
Use the tracert command to trace the gateways by which a packet passes from source to destination for network connectivity test and fault location.
Any view
tracert clns
Use the tracert clns command to track the nodes along the route that leads to a specified destination.
Any view
traffic behavior
Use the traffic behavior command you can define a traffic behavior and enter the behavior view.
System view
traffic classifier
Use the traffic classifier command to define a class and enter the class view.
System view
Use the
Traffic Behavior view
Use the
Frame Relay Class view
Use the
RIP Protocol view
RIP MBGP Address Family view
transform
Use the transform command to set a security protocol used by a proposal.
IPSec Proposal view
translate ip
Use the translate ip command to configure an X2T forwarding route from IP network to X.25 network.
System view
translate x25
Use the translate x25 command to configure an X2T forwarding route from X.25 network to IP network.
System view
transmit gain
Use the transmit gain command to configure the voice
Voice Subscriber-Line view
Use the
UBR,
ATM PVC view
Use the
R2 CAS view
Use the
Voice Entity view
ts
Use the ts command to maintain the trunk circuit of the specified timeslot.
R2 CAS view
ttl
Use the ttl command to configure TTL of ICMP test packets.
HWPing Test Group view
ttl expiration
Use the ttl expiration command to configure the router to forward ICMP responses by local IP routing when the MPLS TTL expires.