3Com Router 5000/6000 Family | 9 |
Command Reference |
|
balance
Use the balance command to configure the number of routes participating in BGP load balancing.
BGP view
Use the
System view
baudrate
Use the baudrate command to set the baud rate of a serial interface.
Serial Interface view
bert
Use the bert command to set test error bit for line Bit.
CE3 interface view
bert (CT1/PRI Interface)
Use the bert command to start a BERT test on the CT1/PRI interface.
CT1/PRI Interface view
bert (CT3 Interface)
Use the bert command to start a BERT test on the CT3 interface.
CT3 Interface view
bgp
Use the bgp command to enable BGP and enter the BGP view.
System view
This command is used to enable and disable BGP as well as to specify the local AS number of BGP.
bims boot request
Use the bims boot request command to enable the BIMS device to access the branch intelligent management system (BIMS) center at startup.
System view
bims
Use the bims
System view
bims enable
Use the bims enable command to enable BIMS.
System view
bims interval
Use the bims interval command to configure the interval for accessing the BIMS center. When the interval is set to 0, the BIMS device does not access the BIMS center regularly.
System view
bims ip address
Use the bims ip address command to configure the IP address and port number of the BIMS center.
System view
bims request
Use the bims request command to have the BIMS device access the BIMS center.
System view
Use the
DHCP server.
Global DHCP Address Pool view
bims sharekey
Use the bims sharekey command to configure the shared key between the BIMS device and the BIMS center.
System view
bims source
Use the bims source
BIMS device. It can be the IP address of a port on the router.
System view
bims
Use the bims
System view