Allied Telesis AT-WA1104G-10 manual DHCPv6

Page 41

 

 

 

 

 

 

 

Features in 291-05

 

 

 

41

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CR

Module

Level

Description

AR400

AR7x5

AR7x0S

 

Rapier i

AT8800-

AT-8600

 

AT-8700XL

x90048-

AT-9900

AT-9800

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CR00015938

DHCPv6

2

For DHCPv6, the router or switch now supports Prefix Delegation according to

Y

Y

Y

 

Y

Y

-

 

-

Y

Y

Y

 

 

 

RFC 3633. The previous implementation was according to an Internet draft and

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

did not interoperate with other DHCPv6 implementations.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This issue has been resolved.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CR00015974

DHCPv6

2

The DHCPv6 client regularly wrote the file client6.dhc, which over time caused

Y

Y

Y

 

Y

Y

-

 

-

Y

Y

Y

 

 

 

unnecessary Flash compactions.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This issue has been resolved. The DHCPv6 client now only writes the file when

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

the contents are different from the previous time that the file was written. This

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

greatly reduces the number of Flash compactions caused.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CR00015984

DHCPv6

2

DHCPv6 authentication did not work correctly.

Y

Y

Y

 

Y

Y

-

 

-

Y

Y

Y

 

 

 

This issue has been resolved. You can now configure the router or switch to

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

authenticate DHCPv6 exchanges.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CR00015989

TPAD

2

When using the TPAD autodial feature and sending multiple transactions over a

Y

Y

Y

 

Y

-

-

 

-

-

-

-

 

 

 

TCP/IP connection, the router or switch responded to good APACS packets by

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

sending an ACK. This ACK was unnecessary and could cause interoperability

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

issues.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This issue has been resolved. The router or switch no longer sends the ACK in

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

these circumstances.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CR00016034

IP Gateway,

2

Previously it was not possible to add a static ARP entry for the corresponding

Y

Y

Y

 

Y

Y

-

 

-

-

-

Y

 

Firewall

 

partner address of a /31 subnet interface.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This issue has been resolved. The router or switch will now also allow /31 ARP

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

requests to pass through the firewall.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CR00016060

IGMP

2

If a port was disabled from being an All Routers group port for IGMP, and that

Y

-

Y

 

Y

Y

Y

 

Y

Y

Y

Y

 

 

 

port received All Routers group traffic, it would incorrectly be added to the All

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Routers group.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

This issue has been resolved.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Version 291-10

C613-10488-00 REV G

Image 41
Contents Models Series Release File Date Size bytes GUI file Maintenance VersionEnabling and Installing this Release Enabling and Installing this ReleaseLevels3 LevelsIP Gateway SwitchingSnooping CR00018663 ModuleCR00018691 CR00018693CR00018514 CR00018530 Module Level DescriptionCR00000444 Policy attack commandCR00000484 CR00001231Vlan Protocol=any and ipprotocol=icmpInstall, MIB VPN, GUI TTY Create configIgmp PIM6 Isakmp ATM CR00016985CR00016989 CR00017081CR00017227 CR00017226CR00017255 CR00017256QoS CR00017368CR00017456 CR00017488CR00017634 CR00017518CR00017659 CR00017662PIM Show config dynam or saved by the command create configCommand add fire policy=name rule=number act=allow int=int GUI FileBridge Install, Snmp Install CR00010984 CR00010979CR00011223 CR00011259Conf dyn=ip PingCR00013543 CR00013494CR00013635 MaxttlCR00013920 CR00013832CR00014103 CR00014137CR00014330 CR00014304CR00014879 CR00015466CR00016578 CR00016452CR00016735 CR00016925GUI, Switch AuthenticationProcess counters CR00012822CR00016099 MacffRadius CR00017532 CR00017482WAN Load CR00017701CR00017869 Have been. This could cause serious routing issuesCarried out correctly CR00018039Enhancements CR00007737 You enable the firewall session licenseCR00010003 CR00011533CR00013041 CR00012980CR00013500 CR00013527CR00015592 CR00015569CR00015736 CR00015822DHCPv6 SYN ConfigGUI, Firewall CR00016365 CR00016364CR00016379 CR00016394CR00016526 CR00016489CR00016576 CR00016621Isdn CR00016941 CR00016940CR00017006 CR00017031VLAN, Igmp CR00017257 CR00008225 System temperature commandCR00009036 CR00010518PIM, PIM6 Asyn Switch, MIBCR00016463 CR00016228Type=temporary CR00016799CR00011560 CR00000396CR00013976 CR00015543CR00014667 CR00014288CR00015432 ADSL, GUICreate isakmp policy=name other parameters CR00016150Address of the policy CR00016221CR00016285 CR00016234CR00016361 Cu SFPsCR00016523 CR00016459Status in the entry labelled Main fan CR00016776 CR00016758CR00016785 CR00016977Logging CR00013787CR00013813 CR00013963CR00014145 Was enabled enable bgp autosoftupdateCR00016314 CR00010511Ethernet IGMP, VlanCR00014269 CR00014228CR00014298 CR00014323CR00014748 CR00014714CR00014795 CR00014834Switch, Macff CR00015396 CR00015348CR00015474 CR00015638CR00015949 CR00015936CR00015971 CR00015937GUI, Igmp CR00007000CR00009274 CR00009302CR00010136 Using igmpproxy=offCR00012230 CR00012493CR00012832 CR00012585CR00012858 CR00013150CR00013694 CR00013629CR00014038 CR00014047GUI, Log CR00014652 CR00014328CR00014659 CR00014724PIMv6 CR00015155 CR00015148CR00015159 CR00015258CR00015798 CR00015666CR00016058 CR00015915CR00004677 Disable debug activeCR00009087 Core, UtilityCR00013045 CR00012602CR00013112 CR00013188CR00013463 Command create config, set summertime came before enableCR00013589 CR00013640Ddns CR00014778 CR00014750VLAN, Bridging CR00015080Many CR00013992 Main chassis fan in the output of the show system commandWays System LED flashes in a single flash pattern CR00014067Command SHow BOOTp RELAy DELete BOOTp RELAy=ipadd INTerface=interfaceCR00014172 CR00014238CR00014241 CR00014354 CR00014300MAC-forced forwarding CR00014728 CR00014715DNS CR00015628 CR00014845CR00015269 CR00014960 Caused the switch to reboot This issue has been resolvedCR00015102 CR00015585CR00013270 CR00015678Queues of buffer resource CR00014306Associated with that traffic class or flow group CR00014959Snooping CR00015510Igmp queries, PIM messages, Ospf messages, and RIP messages CR00014222Support for the new x900-48FS switch-CR00016662 Support for the new x900-48FS switch-CR00016662Igmp snooping fast leave in multiple host mode-CR00017482 Igmp snooping fast leave in multiple host mode-CR00017482Igmp Snooping Support for the new Rapier 48w switch Support for the new Rapier 48w switchBacking up the configuration with SNMP-CR00016221 Backing up the configuration with SNMP-CR00016221Set the load parameters Upload the file Snmp ASN.01 BER Padding-CR00016523 Bits Value decimal Value hex Asnberpadding setting Encoding