Allied Telesis AT-WA1104G-10 manual Enabling and Installing this Release

					Enabling and Installing this Release	2
Models	Series	Release File	Date	Size (bytes)	GUI file
AT-8824, AT-8848	AT-8800	86291-10.rez	24 July 2007	4587048	8824_291-10_en_d.rsc
					8848_291-10_en_d.rsc
AT-8948, AT8948i, x900-48FE, x900-48FE-N,	x900-48	89291-10.rez	24 July 2007	4884216	-
x900-48FS
AT-9924T, AT-9924SP, AT-9924T/4SP	AT-9900	89291-10.rez	24 July 2007	4884216	9924_291-10_en_d.rsc
AT-9812T, AT-9816GB	AT-9800	sb291-10.rez	24 July 2007	3988344	9812_291-10_en_d.rsc
					9816_291-10_en_d.rsc

Caution: Using a maintenance version on the wrong model may cause unpredictable results, including disruption to the network.

This maintenance release note should be read in conjunction with the following documents:

■the Release Note for Software Version 2.9.1, available from www.alliedtelesis.co.nz/documentation/relnotes/relnotes.html, which describes the new features since Version 2.8.1

■your router or switch’s Document Set for Software Release 2.9.1. This document set is available on the CD-ROM that shipped with your router or switch, or from www.alliedtelesis.co.nz/documentation/documentation.html

Caution: Information in this release note is subject to change without notice and does not represent a commitment on the part of Allied Telesis, Inc. While every effort has been made to ensure that the information contained within this document and the features and changes described are accurate, Allied Telesis, Inc. can not accept any type of liability for errors in or omissions arising from the use of this information.

Enabling and Installing this Release

To use this maintenance release you must have a base release license for Software Release 2.9.1. Contact your distributor or reseller for more information about licences. To enable this release and install it as the preferred release, use the commands:

enable rel=xx291-10.rez num=2.9.1

set install=pref rel=xx291-10.rez

where xx is the prefix to the filename, as shown in the table on page 1. For example, to install the release on an x900-48FE switch, use the commands:

enable rel=89291-10.rez num=2.9.1

set install=pref rel=89291-10.rez

Version 291-10

C613-10488-00 REV G