Allied Telesis AT-WA1104G-10 manual CR00014750, CR00014778, VLAN, Bridging, CR00015080, CR00015130

Features in 291-04

80

CR

Module

Level

Description

AR400

AR7x5

AR7x0S

Rapier i

AT8800-

AT-8600

AT-8700XL

x90048-

AT-9900

AT-9800

CR00014750

DHCP

4

Previously, when a user entered the command delete dhcp range=range

Y

Y

Y

Y

Y

Y

Y

Y

Y

Y

ip=ipadd, the router or switch would display an “Operation successful”

message, even when the client entry in question was unused.

This issue has been resolved. For unused clients, this command now results in the

following new message:

“Nothing to delete, client is unused.”

CR00014778

VLAN, Bridging

4

It was possible to specify a value of 0 for the ageingtimer parameter in the

Y

–

Y

Y

–

–

–

–

–

–

command add and set vlan=vlan bridge, even though this value was

meaningless.

This issue has been resolved. The lowest valid value for ageingtimer is 1.

CR00015080

ATM

4

When an SHDSL or ADSL interface re-trained after having been in a “link up”

Y

–

–

–

–

–

–

–

–

–

state, spurious error messages could appear on the console.

This issue has been resolved. The messages were not genuine error messages and

no longer appear.

CR00015130

Switch

4

The following commands have been deprecated in software versions 2.9.1 and

–

–

–

–

–

–

–

Y

Y

–

later, and therefore (correctly) have no effect on the switch:

set switch port=number thrashlimit=value

set switch port=number thrashrefill=value

Previously, if a user entered these commands, the switch incorrectly displayed an

“Operation successful” message.

This issue has been resolved. The switch now displays a warning message

indicating that the commands are deprecated.

For information about the commands that replace these commands, see the

“Limiting Rapid MAC Movement” section of the Switching chapter of the

Software Reference.

Version 291-10

C613-10488-00 REV G