Honeywell Q7055A user manual

Page 1

Honeywell

BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN

Q7055A

BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN

INSTALLATION INSTRUCTION & USER MANUAL

Quick Setup

In order to setup the BNA device properly, the following connections are prerequisite:

•Null-Modem cable connected to a PC running a VT100 terminal emulation program or a VT100 compatible terminal (refer to Table 6-1: Terminal settings)

•LAN connection either via UTP (RJ45 connector) or AUI.

•Power connection.

•An active FTP-Server machine on the LAN

The following BNA Bootloader commands are mandatory for setting up the BNA (for a detailed command description, refer to chapter 6.5 Command Description on Page

31):

np	Basic network parameters
dc	Download configuration
load	Load executable from FTP server

Before the application firmware is started it is recommended to add some users (user roles) using command um (refer to chapter 6.5.8 um - User management on Page 37).

After that the BNA device can be installed at its final operating location.

Image 1

Contents Q7055A Technical Data Table of Contents Tips & Tricks FAQs Glossary Cables and ConnectorsAbout BNA Building Network Adapter BNA-1C/2CS/2DN Building Network Adapter BNA-1C/2CS/2DN Location of Parts and Controls ResetFront Side ModeCol Ch1 PowerCh2 HeartbeatRear Side Ch1/Ch2 Bus Termination Switches11 AC/DC 10 Ch112 RS232 14 10BaseTPieces Item Before InstallationWA RN I NG Single Device BNA Operating PositionsWall Mounting Stacked DevicesPut the BNA-adapter with the topside down on the desk Figure Building Network Adapter BNA-1C/2CS/2DN Connections Power ConnectionField Bus Connection Ch1 / Ch2 Bus Termination SwitchNormal DisabledFS90-Bus connections XD508 compatible bus terminationL1 Bus Termination XD508 compatible bus termination enabledStartup Behavior BNA BootloaderRED Operating Modes Switching the Operating ModeBuilding Network Adapter BNA-1C/2CS/2DN Switching BNA Operating Mode Device Setup Command Description on Basic network parameters CA UT I on Command Description Np Basic network parameters Help or ?Dc Download configuration Building Network Adapter BNA-1C/2CS/2DN Building Network Adapter BNA-1C/2CS/2DN Load Load executable Parameters may be wrong is acceptableRun Execute installed software Ver Show installed softwarePing ping Um User managementBuilding Network Adapter BNA-1C/2CS/2DN User AdminPriv Whoami Who am Login Login as different userBuilding Network Adapter BNA-1C/2CS/2DN DB9F Null Modem Cable Cables and Connectors2shows how to configure a Null Modem Cable DB9F 1 RJ45 Connector Ethernet ConnectorsConnecting a BNA to a Hub Pin Number Signal NameStraight through pinning for BNA to Ethernet Hub connections Connecting a BNA to a WorkstationCrossover pinning for BNA to workstation direct- connections AUI ConnectorGND Tips & Tricks BNA bootloader np display followed by EnterFAQs Glossary Building Network Adapter BNA-1C/2CS/2DN Page Honeywell