Honeywell Q7055A user manual Building Network Adapter BNA-1C/2CS/2DN

Page 26

BUILDING NETWORK ADAPTER BNA-1C/2CS/2DN

2.Wait till the heartbeat LED starts flashing RED, then press the Mode Button.

3.The heartbeat flashing immediately stops and the LED is permanently on. The operating modes are displayed using the LAN status LEDs Lnk, Tx, Rx. The Normal Mode is represented via the Lnk LED.

4.Now push the Mode Button again and the Tx LED will also be switched on. Two LEDs on means Stay in Bootloader Mode is selected.

5.To accept one of the modes, push the Mode Button again and hold it for about 1 second. The BNA Bootloader feedback that the mode has been accepted is indicated with all Mode LEDs and the heartbeat LED flashing four times.

If there is no need to change the mode after the mode button has been pressed, then just stop pressing the mode button. The BNA device will continue with its normal work after a few seconds.

26

EN1B-0198GE51 R0801

Image 26
Contents Q7055A Technical Data Table of Contents Cables and Connectors Tips & Tricks FAQs GlossaryAbout BNA Building Network Adapter BNA-1C/2CS/2DN Building Network Adapter BNA-1C/2CS/2DN Front Side ResetLocation of Parts and Controls ModeCol Ch2 PowerCh1 HeartbeatCh1/Ch2 Bus Termination Switches Rear Side12 RS232 10 Ch111 AC/DC 14 10BaseTBefore Installation Pieces ItemWA RN I NG BNA Operating Positions Single DeviceStacked Devices Wall MountingPut the BNA-adapter with the topside down on the desk Figure Building Network Adapter BNA-1C/2CS/2DN Power Connection ConnectionsBus Termination Switch Field Bus Connection Ch1 / Ch2FS90-Bus connections DisabledNormal XD508 compatible bus terminationXD508 compatible bus termination enabled L1 Bus TerminationBNA Bootloader Startup BehaviorRED Switching the Operating Mode Operating ModesBuilding Network Adapter BNA-1C/2CS/2DN Switching BNA Operating Mode Device Setup Command Description on Basic network parameters CA UT I on Command Description Help or ? Np Basic network parametersDc Download configuration Building Network Adapter BNA-1C/2CS/2DN Building Network Adapter BNA-1C/2CS/2DN Parameters may be wrong is acceptable Load Load executablePing ping Ver Show installed softwareRun Execute installed software Um User managementBuilding Network Adapter BNA-1C/2CS/2DN Priv AdminUser Login Login as different user Whoami Who amBuilding Network Adapter BNA-1C/2CS/2DN Cables and Connectors DB9F Null Modem Cable2shows how to configure a Null Modem Cable DB9F Ethernet Connectors 1 RJ45 ConnectorPin Number Signal Name Connecting a BNA to a HubConnecting a BNA to a Workstation Straight through pinning for BNA to Ethernet Hub connectionsAUI Connector Crossover pinning for BNA to workstation direct- connectionsGND BNA bootloader np display followed by Enter Tips & TricksFAQs Glossary Building Network Adapter BNA-1C/2CS/2DN Page Honeywell