Compaq D300v Series manual Removing the Front Bezel

Page 14

Hardware Upgrades

3.Remove the two screws that secure the access panel to the computer chassis.

Remove the right access panel to upgrade memory or an expansion card. Remove the left access panel to upgrade a drive.

4.Slide the access panel back about 1 inch (2.5 cm), then lift it away from and off the unit.

Removing the Computer Access Panel

To replace the access panel, reverse steps 1-4.

Removing the Front Bezel

Remove the front bezel to upgrade a drive.

1.Shut down the operating system properly, then turn off the computer and any external devices. Disconnect the power cord from the power outlet and disconnect any external devices.

Compaq Evo D300 User’s Guide

2-3

Image 14

Contents User’s Guide Page Contents Setup Utility Intel Celeron Models Index Quick Setup Unpack the ComputerConfirm the Voltage Setting Connect External Devices Connect the monitor, mouse, keyboard, and network cablesConnect the Power Cords Front Panel Components Front Panel ComponentsTurning Off the Personal Computer Hardware Upgrades Installation SequenceRemoving the Access Panels Removing the Front Bezel Installing Additional Memory Memory Module Installation Hardware Upgrades Installing or Removing an Expansion Card Removing a 5.25 Inch Drive Hardware Upgrades Removing a Diskette Drive or Hard Drive Removing the Diskette Drive To replace the drive cage, reverse steps Hardware Upgrades Compaq Evo D300 User’s Guide Setup Utility Intel Pentium 4 Models Setup UtilityUsing Setup Utility Start Shut Down Restart the ComputerStandard Cmos Setup Screen Standard Cmos Setup ScreenAdvanced Cmos Setup Screen Advanced Cmos Setup ScreenAdvanced Chipset Setup Screen Advanced Chipset Setup ScreenPower Management Setup Screen Power Management Setup ScreenPCI/Plug and Play Setup Screen PCI/Plug and Play Setup ScreenPeripheral Setup Screen Hardware Monitor Setup ScreenChange User Password Screen Auto-Detect Hard Disks ScreenChange Supervisor Password Screen Auto Configuration with Optimal Settings ScreenSave Settings and Exit Screen Exit Without Saving ScreenSetup Utility Intel Celeron Models Computer Setup Utilities F10Setup Utility Intel Celeron Models Using Computer Setup Utilities ExitComputer Setup Drive Type Emulation Options Multisector Transfers IDE ATA devicesonly Translation Parameters IDE Disks only Primary IDE Controller To boot one time from a device other than Post Disable MBR Security before MBR Security is enabled This option does not affect power management Uuid Universal Unique Identifier Description Computer Setup Computer Setup Battery Replacement Replacing the BatteryBattery and battery holder Lift the battery out of its holder Routine Computer Care and Shipping Preparation Routine Computer CareSafety CD-ROM Drive PrecautionsCleaning OperationShipping Preparation Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Power Cord Set Requirements Federal Communications Commission Notice Agency NoticesRegulatory Compliance Identification Numbers Cables ModificationsMouse Compliance Statement Canadian Notice Avis CanadienEuropean Union Notice Japanese Notice Energy Star ComplianceGerman Ergonomics Notice Compliance with International Regulations Laser SafetyCdrh Regulations Laser Product Label Laser InformationBattery Replacement Notice Index Index-2