Compaq D300v Series manual Auto-Detect Hard Disks Screen, Change User Password Screen

Page 33

Setup Utility (Intel Pentium 4 Models)

■System Temperature

■CPU Fan Speed

■Chassis Fan Speed

■Vccp

■+1.5V

■+1.8V

■+3.3V

■+5.0V

■+12.0V

■HVCC (+3.3 VSB)

Auto-Detect Hard Disks Screen

The Auto-Detect Hard Disks screen is used to configure all hard disk parameters. This screen shows the standard settings that are shipped on the system.

If a new hard disk is installed, choosing the Auto-Detect option allows the system to detect and enter the correct settings for the new hard disk.

Change User Password Screen

The Change User Password screen is used to change the user password. The default setting is no password. Once a password is set, a user must enter the password to change parameters using the Setup Utility.

The supervisor password must be set to enable the use of a user password.

Enter the new user password in the dialog box, and then press the

Enter key.

To remove or disable the set password, enter the current password, then press Enter when prompted to enter a new password.

Compaq Evo D300v User’s Guide

3-9

Image 33

Contents User’s Guide Page Contents Setup Utility Intel Celeron Models Index Unpack the Computer Quick SetupConfirm the Voltage Setting Connect the monitor, mouse, keyboard, and network cables Connect External DevicesConnect the Power Cords Front Panel Components Front Panel ComponentsTurning Off the Personal Computer Installation Sequence Hardware UpgradesRemoving the Access Panels Removing the Front Bezel Installing Additional Memory Memory Module Installation Hardware Upgrades Installing or Removing an Expansion Card Removing a 5.25 Inch Drive Hardware Upgrades Removing a Diskette Drive or Hard Drive Removing the Diskette Drive To replace the drive cage, reverse steps Hardware Upgrades Compaq Evo D300 User’s Guide Setup Utility Setup Utility Intel Pentium 4 ModelsStart Shut Down Restart the Computer Using Setup UtilityStandard Cmos Setup Screen Standard Cmos Setup ScreenAdvanced Cmos Setup Screen Advanced Cmos Setup ScreenAdvanced Chipset Setup Screen Advanced Chipset Setup ScreenPower Management Setup Screen Power Management Setup ScreenPCI/Plug and Play Setup Screen PCI/Plug and Play Setup ScreenHardware Monitor Setup Screen Peripheral Setup ScreenAuto-Detect Hard Disks Screen Change User Password ScreenAuto Configuration with Optimal Settings Screen Change Supervisor Password ScreenExit Without Saving Screen Save Settings and Exit ScreenComputer Setup Utilities F10 Setup Utility Intel Celeron ModelsSetup Utility Intel Celeron Models Exit Using Computer Setup UtilitiesComputer Setup Drive Type Emulation Options Multisector Transfers IDE ATA devicesonly Translation Parameters IDE Disks only Primary IDE Controller To boot one time from a device other than Post Disable MBR Security before MBR Security is enabled This option does not affect power management Uuid Universal Unique Identifier Description Computer Setup Computer Setup Replacing the Battery Battery ReplacementBattery and battery holder Lift the battery out of its holder Routine Computer Care Routine Computer Care and Shipping PreparationCleaning CD-ROM Drive PrecautionsSafety OperationShipping Preparation Preventing Electrostatic Damage Electrostatic DischargeGrounding Methods Power Cord Set Requirements Agency Notices Regulatory Compliance Identification NumbersFederal Communications Commission Notice Modifications Mouse Compliance StatementCables Avis Canadien Canadian NoticeJapanese Notice Energy Star Compliance European Union NoticeGerman Ergonomics Notice Laser Safety Cdrh RegulationsCompliance with International Regulations Laser Information Laser Product LabelBattery Replacement Notice Index Index-2