Compaq D300v Series manual Grounding Methods

Page 60

Electrostatic Discharge

Grounding Methods

There are several methods for grounding. Use one or more of the following methods when handling or installing electrostatic-sensitive parts:

■Use a wrist strap connected by a ground cord to a grounded workstation or computer chassis. Wrist straps are flexible straps with a minimum of 1 Megaohm +/- 10 percent resistance in the ground cords. To provide proper ground, wear the strap snug against the skin.

■Use heelstraps, toestraps, or bootstraps at standing workstations. Wear the straps on both feet when standing on conductive floors or dissipating floor mats.

■Use conductive field service tools.

■Use a portable field service kit with a folding static-dissipating work mat.

If you do not have any of the suggested equipment for proper grounding, contact your Compaq authorized dealer, reseller, or service provider.

For more information on static electricity, contact your Compaq authorized dealer, reseller, or service provider.

C-2	Compaq Evo D300v User’s Guide

Image 60

Contents User’s Guide Page Contents Setup Utility Intel Celeron Models Index Quick Setup Unpack the ComputerConfirm the Voltage Setting Connect External Devices Connect the monitor, mouse, keyboard, and network cablesConnect the Power Cords Front Panel Components Front Panel ComponentsTurning Off the Personal Computer Hardware Upgrades Installation SequenceRemoving the Access Panels Removing the Front Bezel Installing Additional Memory Memory Module Installation Hardware Upgrades Installing or Removing an Expansion Card Removing a 5.25 Inch Drive Hardware Upgrades Removing a Diskette Drive or Hard Drive Removing the Diskette Drive To replace the drive cage, reverse steps Hardware Upgrades Compaq Evo D300 User’s Guide Setup Utility Intel Pentium 4 Models Setup UtilityUsing Setup Utility Start Shut Down Restart the ComputerStandard Cmos Setup Screen Standard Cmos Setup ScreenAdvanced Cmos Setup Screen Advanced Cmos Setup ScreenAdvanced Chipset Setup Screen Advanced Chipset Setup ScreenPower Management Setup Screen Power Management Setup ScreenPCI/Plug and Play Setup Screen PCI/Plug and Play Setup ScreenPeripheral Setup Screen Hardware Monitor Setup ScreenChange User Password Screen Auto-Detect Hard Disks ScreenChange Supervisor Password Screen Auto Configuration with Optimal Settings ScreenSave Settings and Exit Screen Exit Without Saving ScreenSetup Utility Intel Celeron Models Computer Setup Utilities F10Setup Utility Intel Celeron Models Using Computer Setup Utilities ExitComputer Setup Drive Type Emulation Options Multisector Transfers IDE ATA devicesonly Translation Parameters IDE Disks only Primary IDE Controller To boot one time from a device other than Post Disable MBR Security before MBR Security is enabled This option does not affect power management Uuid Universal Unique Identifier Description Computer Setup Computer Setup Battery Replacement Replacing the BatteryBattery and battery holder Lift the battery out of its holder Routine Computer Care and Shipping Preparation Routine Computer CareCD-ROM Drive Precautions CleaningSafety OperationShipping Preparation Electrostatic Discharge Preventing Electrostatic DamageGrounding Methods Power Cord Set Requirements Agency Notices Regulatory Compliance Identification NumbersFederal Communications Commission Notice Modifications Mouse Compliance StatementCables Canadian Notice Avis CanadienEuropean Union Notice Japanese Notice Energy Star ComplianceGerman Ergonomics Notice Laser Safety Cdrh RegulationsCompliance with International Regulations Laser Product Label Laser InformationBattery Replacement Notice Index Index-2