Compaq D300v Series manual Removing a 5.25 Inch Drive

Page 19

Hardware Upgrades

When you install an expansion card, make sure you press firmly on the card so that the entire connector seats properly in the expansion card socket.

10.Replace the screw at the top of the expansion slot.

11.Replace the access panel.

12.Connect external cables to the installed card, if needed. Reconfigure the computer, if necessary.

Removing a 5.25 Inch Drive

1.Shut down the operating system properly, then turn off the computer and any external devices, then disconnect the power cord from the power outlet.

2.Remove both access panels.

3.Remove the front bezel.

4.Disconnect the power, data, and audio cables, as necessary, from the back of the drive.

2-8	Compaq Evo D300 User’s Guide

Image 19

Contents User’s Guide Page Contents Setup Utility Intel Celeron Models Index Unpack the Computer Quick SetupConfirm the Voltage Setting Connect the monitor, mouse, keyboard, and network cables Connect External DevicesConnect the Power Cords Front Panel Components Front Panel ComponentsTurning Off the Personal Computer Installation Sequence Hardware UpgradesRemoving the Access Panels Removing the Front Bezel Installing Additional Memory Memory Module Installation Hardware Upgrades Installing or Removing an Expansion Card Removing a 5.25 Inch Drive Hardware Upgrades Removing a Diskette Drive or Hard Drive Removing the Diskette Drive To replace the drive cage, reverse steps Hardware Upgrades Compaq Evo D300 User’s Guide Setup Utility Setup Utility Intel Pentium 4 ModelsStart Shut Down Restart the Computer Using Setup UtilityStandard Cmos Setup Screen Standard Cmos Setup ScreenAdvanced Cmos Setup Screen Advanced Cmos Setup ScreenAdvanced Chipset Setup Screen Advanced Chipset Setup ScreenPower Management Setup Screen Power Management Setup ScreenPCI/Plug and Play Setup Screen PCI/Plug and Play Setup ScreenHardware Monitor Setup Screen Peripheral Setup ScreenAuto-Detect Hard Disks Screen Change User Password ScreenAuto Configuration with Optimal Settings Screen Change Supervisor Password ScreenExit Without Saving Screen Save Settings and Exit ScreenComputer Setup Utilities F10 Setup Utility Intel Celeron ModelsSetup Utility Intel Celeron Models Exit Using Computer Setup UtilitiesComputer Setup Drive Type Emulation Options Multisector Transfers IDE ATA devicesonly Translation Parameters IDE Disks only Primary IDE Controller To boot one time from a device other than Post Disable MBR Security before MBR Security is enabled This option does not affect power management Uuid Universal Unique Identifier Description Computer Setup Computer Setup Replacing the Battery Battery ReplacementBattery and battery holder Lift the battery out of its holder Routine Computer Care Routine Computer Care and Shipping PreparationOperation CD-ROM Drive PrecautionsCleaning SafetyShipping Preparation Preventing Electrostatic Damage Electrostatic DischargeGrounding Methods Power Cord Set Requirements Regulatory Compliance Identification Numbers Agency NoticesFederal Communications Commission Notice Mouse Compliance Statement ModificationsCables Avis Canadien Canadian NoticeJapanese Notice Energy Star Compliance European Union NoticeGerman Ergonomics Notice Cdrh Regulations Laser SafetyCompliance with International Regulations Laser Information Laser Product LabelBattery Replacement Notice Index Index-2