THE
February 2007
Stopping a Transmitter
To use the Programmer to Stop the transmitter’s meter reading broadcast, align the optical port and the LED and touch the Stop Radio button “T”. If the port and the LED are aligned, you’ll hear a beep and see these messages that indicate success:
•Stop
•Done
Here’s what you would see if you stopped transmitter # 72110115.
Changing the Odometer setting
The most common use of the SET ODOMETER function is to clear a Tamper condition reported by a Transmitter. Besides clearing the tamper, the SET ODOMETER function will also allow you to change the meter reading stored in the transmitter.
Changing the odometer setting is performed in two steps:
•Perform a READ function
•Enter the new odometer value and perform the SET ODOMETER function
The READ function is described above. Once the Badger ORION® transmitter has been successfully read, you can continue with the SET ODOMETER function.
To use the Programmer to clear the tamper (the transmitter’s meter reading matches the odometer value), press the PROGRAM “P” key once the READ function has completed. The Programmer will clear the tamper without changing the stored meter reading.
To use the Programmer to change the transmitter’s stored meter odometer value, enter the odometer value you want the transmitter to store into the odometer field as follows. First, use the delete key on the keyboard below the screen (upper left corner, first press the
Page 61 of 73