Ampro Corporation Littleboard 550 manual Video Interfaces J3, J4, J5, J31, CRT Interface

Page 61

Chapter 3

Hardware

Video Interfaces (J3, J4, J5, J31)

The Northbridge (VT8606) chip provides the graphics control and video signals to the traditional glass CRT monitors and the LCD and LVDS flat panel displays. The chip features are listed below:

CRT features:

Supports a max resolution of 1600 x 1200 with video frame buffer set at 8MB

Supports a maximum allowable video frame buffer size of 32MB shared memory

AGP 4X graphics (always enabled)

Compliant with Rev 2.0 of AGP Interface

Flat Panel features:

Supports (3.3V, 5V, or 12V) output to both DSTN and TFT flat panels through a 36-bit interface

Supports TFT panel sizes from VGA (320x480) up to SXGA+ and UXGA+ (1400x1050).

Supports LCD VGA and SVGA panels with 9-, 12-, 18-bit interface (1 Pixel/Clock)

Supports UXGA and SXGA active matrix panels with 1x24-bit interface (2 Pixels/Clock)

Supports 1 or 2 channel LVDS outputs

CRT Interface

Table 3-23. CRT Interface Pin/Signal Descriptions (J5)

Pin #

Signal

Description

1

RED

Red – This is the Red analog output signal to the CRT.

 

 

 

2

GND

Ground

3

GREEN

Green – This is the Green analog output signal to the CRT.

4

GND

Ground

5

BLUE

Blue – This is the Blue analog output signal to the CRT.

 

 

 

6

GND

Ground

7

HSYNC

Horizontal Sync – This signal is used for the digital horizontal sync

 

 

output to the CRT.

8

GND

Ground

9

VSYNC

Vertical Sync – This signal is used for the digital vertical sync output to

 

 

the CRT.

10

+5V

+5 volts +/- 5% through Fuse (F5 is next to J5 connector on board)

Notes: The shaded area denotes power or ground.

LittleBoard 550

Reference Manual

55

Image 61
Contents LittleBoard Single Board Computer Reference Manual Audience Assumptions Contents Appendix a List of Tables Table A-1 Purpose of this Manual SpecificationsReference Material LittleBoard 550 Support Products Related Ampro ProductsOther LittleBoard Products Other Ampro Products Chapter EBX Architecture Product OverviewStacking PC/104 Modules with the LittleBoard Product DescriptionBoard Features Chapter Chapter ATA Block DiagramChip Type Mfg Model Description Function Major Integrated Circuits ICsVIA CPUJack # Signal Description Connector DefinitionsAdditional Components DIMM1Northb Default Jumper # Installed Removed/InstalledIndicator Definition Jumper DefinitionsThb Physical Specifications SpecificationsDimension LittleBoard 550 Dimensions Top view, #1 Mechanical Specifications115 705 415 730 200 050 350 800 600 385 345 Environmental Specifications Power SpecificationsThermal/Cooling Requirements Reference Manual LittleBoard USB OverviewMemory CPU U1Sdram Memory DIMM1 Flash Memory U17Memory Map Interrupt Channel AssignmentsBase Address Function Address MapAddress hex Subsystem VGAPC/104-Plus Interface J21 Pin # Signal Input Description OutputREQ0 IDSEL0GNT1 CLK2CLK0 REQ2Intd IntaREQ1 IDSEL1GNT2 CLK3IDSEL3 IDSEL2GNT0 CLK1PC/104 Interface J1A,B,C,D Pin # Signal Description J1 Row aPin # Signal Descriptions J1 Row B DRQ3 DACK3DACK1 DRQ1Pin # Signal Descriptions J1 Row D Pin # Signal Descriptions J1 Row CIRQ14 IRQ15DACK0 DRQ0IDE Interface J12, J17 Pin # Signal DescriptionPdiow PdreqPdior PdiordySDD6 SDD8SDD9 SDD5SDA0 SDA1SDA2 SDCS1#PDCE1 CompactFlash Adapter J23VCC Pdrst PDCE2Floppy Drive Interface J14 Parallel Port Interface J15 Pin # Signal In/Out DescriptionRS485 Serial Port Implementation Serial Interfaces J11, J13DSR1 DCD1RXD1 RTS1DTR2 CTS2DCD3 DSR3DSR4 DCD4RXD4 RTS4Utility 1 Interface J16 Utility InterfacesMouse Interface Utility 2 Interface J24System Management Bus SMBus Component Address Binary USB Signals USB0 and USB1Sdram Eprom Pwrbt SuscBatlow MdataUtility 3 Interface J18 USB Signals USB2 and USB3TX+ Ethernet Interfaces J7, J32Audio Interface J28 Videognd VideolVideor CDLCRT Interface Video Interfaces J3, J4, J5, J31LCD Interface Enavdd Lvds Interface Pin # Signal Description Line ChannelOops! Jumper Bios Recovery Temperature MonitoringMiscellaneous Real Time Clock RTCHot Cable Jumper Watchdog TimerPower Monitor Power Interface J10CPU Fan TAGReference Manual LittleBoard Introduction Accessing Bios Setup VGA DisplayBios Setup Menu Item/Topic Accessing Bios Setup Serial ConsoleBios Setup Opening Screen Bios MenusDrive Configurations and Boot Options Bios Configuration ScreenDate & Time Drive Assignment# of Floppy Drives Bios Settings Drive and Boot Options Boot OrderUser Interface Options Keyboard and Mouse ConfigurationUser Interface Memory Memory Control OptionsPower Management Power Management and Advanced User OptionsAdvanced features On-Board Serial Ports On-Board LPT Port On-Board Controllers Video, Flat Panel, and Audio OptionsOn-Board Video PCI, Plug n Play, and Interrupt Assignments Chapter Bios Setup Chapter Bios Setup Chapter Bios Setup Splash Screen Image Requirements Splash Screen CustomizationConverting the Splash Screen File \splashconvert convert.idf Method Contact Information Appendix a Technical SupportAppendix a Technical Support Connector Designation Pin # Mfg Part Number Appendix B Appendix C LAN Boot Option Accessing PXE Boot Agent Bios Setup PXE Boot Agent Bios SetupPXE Configuration PXE Boot Agent Setup ScreenTCP/IP Configuration RPL Configuration NetWare ConfigurationCRT CD-ROMPost Documentation and Support Software Doc & SW CD-ROMWDT Supported featuresReference Manual LittleBoard