Epson TM-S1000 specifications Document LED Green, Connectors, Offline

Page 16

DOCUMENT LED (Green)

•Lights when the scanner is ready to process documents in the ASF/SF or while the scanner is processing documents.

•Flashes when the scanner is waiting for document insertion.

When waiting for document removal, the ERROR LED flashes as shown below.

Approx.160 ms

Approx.160 ms

• Out except for the cases above.

Connectors

All cables are connected to the connector panel on the lower rear of the scanner.

USB cable securing hook

USB connector

Power supply connector

•Power supply connector:

•USB connector:

•USB cable securing hook:

Connects the power supply unit

Connects the scanner with the host computer interface.

Hooking the USB cable on the USB cable securing hook prevents the cable from falling off.

Offline

The scanner automatically goes offline under the following conditions:

•During power on (including resetting with the interface) until the scanner is ready

•When the scanner cover is opened.

•When the franker cover is opened.

•When an error has occurred.

16

Image 16

Contents Setup Product OverviewHandling 411259105 Rev. ETrademarks For Safety Key to SymbolsDealer or a Seiko Epson service center for advice Manual Content Restriction of UseAbout this Manual Aim of the ManualContents Connecting the Scanner to the Host Computer Application Development InformationPage Features Single Pass ProcessingStandard Equipment Easy OperationFranking Cartridge Interface Product ConfigurationColor Attachments AccessoriesOptions For Multi Feed Models Part Names and FunctionsFor Single Feed Models Power Switch Cover Power SwitchFor All Models Power LED Green LED IndicatorsError LED Orange Document LED Green ConnectorsOffline Processing Modes High-speedConfirmation OverlapProcessing speed For 30 Dpm ModelFor 60 Dpm Model With overlap ConfirmationFor 90 Dpm Model Reading Operation High-speed mode Confirmation mode Selectable processesFranking process Ejection processSensors Paper SensorsEject sensor E Main pocket nearly full sensor FCover Open Sensors Scanner cover open sensor HOther Sensors Franking cartridge sensor JFranking cartridge position sensor K Hopper position sensor MMaintenance Counter Counter Counter type UnitError Status Recoverable ErrorsError LED flash code Error description Recovery measureError LED flash code Error description Unrecoverable Errors Error LED flash codeError Error description Compatibility with the TM-J9000/J9100Product Specifications CPUDpm documents per minute, dpi dots per inch 25.4 mm Scanner Specifications JpegPaper Specifications For multi feed models FrontFront Scannable AreaBack Micr Readable Area Area for Electric EndorsementArea for Franking Front or BackElectrical Characteristics Environmental ConditionsExternal Dimensions and Mass MassPage Installing the Scanner Flow of SetupImportant Notes on Installation Connecting the Scanner to the Host Computer Connecting the Power Supply Unit Use the AC adapter. C as the power supply unitPage Download Software and ManualsSoftware Description Manual TM-S1000 Utility Functions of the UtilityHandling Turning On/OffOpening the Covers Opening the Scanner CoverOpening the Franker Cover Franking Cartridge Installing and Replacing the Franking CartridgeImportant Notes on the Franking Cartridge Handling Pocket Guide Pulling Out the GuidesASF/SF Guide Flow of Single Pass Processing Processing DocumentsImportant Notes on Processing Documents Inserting Checks For multi feed modelsFor single feed models When the documents are ejected, remove the documents Ejecting ChecksCleaning Cleaning the Image ScannerCleaning the Micr Unit Do not use sticky cleaning sheetsRemoving a Paper Jam Preparing for Transport