Epson TM-S1000 Other Sensors, Franking cartridge sensor J, Franking cartridge position sensor K

Page 25

Chapter 1 Product Overview

Other Sensors

Franking cartridge sensor (J)

This sensor detects whether the franking cartridge is installed or not.

Franking cartridge position sensor (K)

The franking cartridge is installed in the franking cartridge holder, and the franking operation is achieved by a motor driving the cartridge holder. The scanner has a franking cartridge sensor for detecting the position of the cartridge holder.

1

Pocket switch board sensor (L) (except for the one pocket model)

The scanner has two pockets, and a switch board for switching the direction of each of the pockets. This sensor detects the position of the switch board.

Hopper position sensor (M)

This sensor is located in the ASF/SF. It detects the position of the hopper, which holds

documents in place.

Paper thickness sensor (N) (only for the multi feed models)

This sensor detects the level difference and thickness in order to determine whether or not paper

has been double fed.

Even if a double feed is detected, it is still possible to obtain MICR and image data that has been read, and to carry out print electronic endorsements and franking.

25

Image 25

Contents Product Overview SetupHandling 411259105 Rev. ETrademarks Key to Symbols For SafetyDealer or a Seiko Epson service center for advice Restriction of Use Manual ContentAbout this Manual Aim of the ManualContents Application Development Information Connecting the Scanner to the Host ComputerPage Single Pass Processing FeaturesStandard Equipment Easy OperationFranking Cartridge Interface Product ConfigurationColor Attachments AccessoriesOptions For Multi Feed Models Part Names and FunctionsFor Single Feed Models Power Switch Cover Power SwitchFor All Models Power LED Green LED IndicatorsError LED Orange Document LED Green ConnectorsOffline High-speed Processing ModesConfirmation OverlapFor 30 Dpm Model Processing speedWith overlap Confirmation For 60 Dpm ModelFor 90 Dpm Model Reading Operation Selectable processes High-speed mode Confirmation modeFranking process Ejection processPaper Sensors SensorsMain pocket nearly full sensor F Eject sensor ECover Open Sensors Scanner cover open sensor HFranking cartridge sensor J Other SensorsFranking cartridge position sensor K Hopper position sensor MCounter Counter type Unit Maintenance CounterRecoverable Errors Error StatusError LED flash code Error description Recovery measureError LED flash code Error description Error LED flash code Unrecoverable ErrorsError Error description Compatibility with the TM-J9000/J9100CPU Product SpecificationsDpm documents per minute, dpi dots per inch 25.4 mm Jpeg Scanner SpecificationsFor multi feed models Front Paper SpecificationsFront Scannable AreaBack Area for Electric Endorsement Micr Readable AreaArea for Franking Front or BackEnvironmental Conditions Electrical CharacteristicsMass External Dimensions and MassPage Installing the Scanner Flow of SetupImportant Notes on Installation Connecting the Scanner to the Host Computer Use the AC adapter. C as the power supply unit Connecting the Power Supply UnitPage Download Software and ManualsSoftware Description Manual Functions of the Utility TM-S1000 UtilityTurning On/Off HandlingOpening the Scanner Cover Opening the CoversOpening the Franker Cover Franking Cartridge Installing and Replacing the Franking CartridgeImportant Notes on the Franking Cartridge Handling Pocket Guide Pulling Out the GuidesASF/SF Guide Flow of Single Pass Processing Processing DocumentsImportant Notes on Processing Documents For multi feed models Inserting ChecksFor single feed models Ejecting Checks When the documents are ejected, remove the documentsCleaning the Image Scanner CleaningDo not use sticky cleaning sheets Cleaning the Micr UnitPreparing for Transport Removing a Paper Jam