Epson TM-S1000 specifications Connecting the Scanner to the Host Computer

Page 40

Connecting the Scanner to the Host Computer

Connect the scanner to a host computer via a USB port.

1 Start the TM-S1000 Utility included on the Utility & Documents CD.

Starting the TM-S1000 Utility causes the USB driver to be installed. Be sure to start the TM-S1000 Utility before connecting the scanner to a host computer.

If the scanner is connected to a host computer before installing the USB driver, the Found New Hardware Wizard will be displayed. In that case, cancel the wizard and start the TM-S1000 Utility to install the USB driver.

2 When the TM-S1000 Utility has started, connect the USB cable from the host computer to the USB upstream connector.

•Be sure to use the USB cable that is included with the scanner.

• Hook the USB cable on the USB cable securing hook as shown in the figure below to prevent the cable from falling off.

USB cable securing hook

USB cable

USB connector

40

Image 40

Contents Setup Product OverviewHandling 411259105 Rev. ETrademarks For Safety Key to SymbolsDealer or a Seiko Epson service center for advice Manual Content Restriction of UseAbout this Manual Aim of the ManualContents Connecting the Scanner to the Host Computer Application Development InformationPage Features Single Pass ProcessingStandard Equipment Easy OperationFranking Cartridge Interface Product ConfigurationColor Attachments AccessoriesOptions For Multi Feed Models Part Names and FunctionsFor Single Feed Models Power Switch Cover Power SwitchFor All Models Power LED Green LED IndicatorsError LED Orange Document LED Green ConnectorsOffline Processing Modes High-speedConfirmation OverlapProcessing speed For 30 Dpm ModelFor 60 Dpm Model With overlap ConfirmationFor 90 Dpm Model Reading Operation High-speed mode Confirmation mode Selectable processesFranking process Ejection processSensors Paper SensorsEject sensor E Main pocket nearly full sensor FCover Open Sensors Scanner cover open sensor HOther Sensors Franking cartridge sensor JFranking cartridge position sensor K Hopper position sensor MMaintenance Counter Counter Counter type UnitError Status Recoverable ErrorsError LED flash code Error description Recovery measureError LED flash code Error description Unrecoverable Errors Error LED flash codeError Error description Compatibility with the TM-J9000/J9100Product Specifications CPUDpm documents per minute, dpi dots per inch 25.4 mm Scanner Specifications JpegPaper Specifications For multi feed models FrontFront Scannable AreaBack Micr Readable Area Area for Electric EndorsementArea for Franking Front or BackElectrical Characteristics Environmental ConditionsExternal Dimensions and Mass MassPage Installing the Scanner Flow of SetupImportant Notes on Installation Connecting the Scanner to the Host Computer Connecting the Power Supply Unit Use the AC adapter. C as the power supply unitPage Download Software and ManualsSoftware Description Manual TM-S1000 Utility Functions of the UtilityHandling Turning On/OffOpening the Covers Opening the Scanner CoverOpening the Franker Cover Franking Cartridge Installing and Replacing the Franking CartridgeImportant Notes on the Franking Cartridge Handling Pocket Guide Pulling Out the GuidesASF/SF Guide Flow of Single Pass Processing Processing DocumentsImportant Notes on Processing Documents Inserting Checks For multi feed modelsFor single feed models When the documents are ejected, remove the documents Ejecting ChecksCleaning Cleaning the Image ScannerCleaning the Micr Unit Do not use sticky cleaning sheetsRemoving a Paper Jam Preparing for Transport