Epson TM-S1000 Flow of Setup, Installing the Scanner, Important Notes on Installation

Page 39

Chapter 2 Setup

Setup

This chapter describes setup and installation of the product.

Flow of Setup

This chapter consists of the following sections along with the setup flow of the product.

1. Installing the Scanner (page 39)

2. Connecting the Scanner to the Host Computer (page 40)

3.Connecting the Power Supply Unit (page 41)

Do not change the settings of the DIP switch under the bottom cover.

Installing the Scanner

You can install this scanner only horizontally.

Important Notes on Installation

2

•The scanner must be installed horizontally.

•Do not place the scanner in dusty locations.

•Do not catch cables or allow foreign matter under the scanner.

•Do not subject the scanner to abnormal impact while it is operating. This may cause defective readings.

39

Image 39

Contents 411259105 Rev. E SetupProduct Overview HandlingTrademarks Key to Symbols For SafetyDealer or a Seiko Epson service center for advice Aim of the Manual Manual ContentRestriction of Use About this ManualContents Application Development Information Connecting the Scanner to the Host ComputerPage Easy Operation FeaturesSingle Pass Processing Standard EquipmentFranking Cartridge Product Configuration InterfaceColor Accessories AttachmentsOptions Part Names and Functions For Multi Feed ModelsFor Single Feed Models Power Switch Power Switch CoverFor All Models LED Indicators Power LED GreenError LED Orange Connectors Document LED GreenOffline Overlap Processing ModesHigh-speed ConfirmationFor 30 Dpm Model Processing speedWith overlap Confirmation For 60 Dpm ModelFor 90 Dpm Model Reading Operation Ejection process High-speed mode Confirmation modeSelectable processes Franking processPaper Sensors SensorsScanner cover open sensor H Eject sensor EMain pocket nearly full sensor F Cover Open SensorsHopper position sensor M Other SensorsFranking cartridge sensor J Franking cartridge position sensor KCounter Counter type Unit Maintenance CounterRecovery measure Error StatusRecoverable Errors Error LED flash code Error descriptionError LED flash code Error description Compatibility with the TM-J9000/J9100 Unrecoverable ErrorsError LED flash code Error Error descriptionCPU Product SpecificationsDpm documents per minute, dpi dots per inch 25.4 mm Jpeg Scanner SpecificationsFor multi feed models Front Paper SpecificationsScannable Area FrontBack Front or Back Micr Readable AreaArea for Electric Endorsement Area for FrankingEnvironmental Conditions Electrical CharacteristicsMass External Dimensions and MassPage Flow of Setup Installing the ScannerImportant Notes on Installation Connecting the Scanner to the Host Computer Use the AC adapter. C as the power supply unit Connecting the Power Supply UnitPage Software and Manuals DownloadSoftware Description Manual Functions of the Utility TM-S1000 UtilityTurning On/Off HandlingOpening the Scanner Cover Opening the CoversOpening the Franker Cover Installing and Replacing the Franking Cartridge Franking CartridgeImportant Notes on the Franking Cartridge Handling Pulling Out the Guides Pocket GuideASF/SF Guide Processing Documents Flow of Single Pass ProcessingImportant Notes on Processing Documents For multi feed models Inserting ChecksFor single feed models Ejecting Checks When the documents are ejected, remove the documentsCleaning the Image Scanner CleaningDo not use sticky cleaning sheets Cleaning the Micr UnitPreparing for Transport Removing a Paper Jam