Appendix B
Default Settings
The scanner is shipped from the factory programmed to a set of default conditions. The default parameter of the scanner has an asterisk ( * ) in the charts on the following pages. If an asterisk is not in the default column then the default setting is Off or Disabled.
Every communication does not support every parameter. If the communica- tion supports a parameter listed in the charts on the following pages, a check mark will appear.
For the scanner to communicate with your host system properly, program it to meet the specific scanning needs. Since each host system is unique, change the default settings to match the host system requirements. For information on how to change the default settings, refer to the Configuration of the Scanner to the Host System section or the ScanSelect™ Scanner Programming Guide.
|
|
|
|
|
|
|
|
|
| Parameter | Default | OCIA | IBM | Key | RS- | Parallel | Light |
|
|
|
| 46XX | Wedge | 232* |
| Pen |
| UPC/EAN | * | T | T | T | T | T | T |
| Code 128 | * | T | T | T | T |
| T |
| Code 93 | * | T | T | T | T |
| T |
| Codabar | * | T | T | T | T |
| T |
| Interleaved 2 of 5 | * | T | T | T | T |
| T |
| (ITF) |
|
|
|
|
|
|
|
| MOD 10 Check |
| T | T | T | T |
| T |
| on ITF |
|
|
|
|
|
|
|
| Code 11 |
| T | T | T | T |
| T |
| Code 39 | * | T | T | T | T |
| T |
| Full ASCII |
| T | T | T | T |
| T |
| Code 39 |
|
|
|
|
|
|
|
| MOD 43 Check |
| T | T | T | T |
| T |
| on Code 39 |
|
|
|
|
|
|
|
| MSI Plessey |
| T | T | T | T |
| T |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
28