Terminals
Adding Terminals
Terminal Setup
Before a terminal can be added to FMU for the first time, the terminal must be set up to recognize FMU. See “Enabling a Terminal for FMU with Direct Connect” on page 50 and “Enabling Terminals for RF Connectivity” on page 52 for detailed information. Once you have enabled a terminal for FMU, you will not need to perform this step again.
To add a terminal to FMU
1.Select the group to which you want to add the terminal.
2.On the File menu, click Add > Terminal.
Figure 15. Adding a Terminal
Serial Number | Enter the serial number for device1. |
IP Address | Enter the IP Address of the terminal. |
|
|
Assigned | Displays the group to which the terminal will be attached. |
Group |
|
|
|
1. See the PRG for your terminal for instructions on finding the serial number.
Terminal Check-in
After a terminal has been enabled for FMU, it communicates with the FMU Server upon reboot, when placed in a dock, or when requested by the server. The server uses the defined group settings to update the terminal at the next specified update. See “Updating Terminals” on page 51 and “Updating RF Terminals” on page 55.
User’s Manual | 37 |