Chapter 5 Terminal to FMU Server Communications
Overview
Prior to installing FMU for the first time, you should set up terminals to com- municate with FMU. This requires the completion of two steps:
1.Establish communication from the terminal(s) to the host computer. Set up a connection using either an RF connection or using Direct Connect with a Datalogic Dock. See the PRG for your terminal type for specific information.
2.Enable FMU on the terminal. See either “Direct Connect” on page 50 or “RF Connection” on page 52.
This section covers the following topics:
“Direct Connect” on page 50
•“Enabling a Terminal for FMU with Direct Connect” on page 50
•“Explore Terminal” on page 51
•“Updating Terminals” on page 51
•“RF Connection” on page 52
•“Terminal Report” on page 58
“RF Connection” on page 52
•“Enabling Terminals for RF Connectivity” on page 52
•“Exploring an RF Terminal” on page 55
•“Updating RF Terminals” on page 55
•“Terminal Configuration Settings” on page 56
•“See Appendix C, “Terminal Report” on page 75 to view a sample report.” on page 58
User’s Manual | 49 |