Datalogic Scanning 1000I manual Retry on ACK NAK Timeout, ACK NAK Timeout Value

Interface Features

RS-232 Interface Features — cont.

Retry on ACK NAK Timeout

Enables/disables retry after the configurable ACK NAK Timeout Value (set in the following fea- ture) has expired.

START / END

PROGRAMMING BARCODES

Disable Retry on ACK NAK Timeout

Enable Retry on ACK NAK Timeout

DEFAULT

ACK NAK Timeout Value

START / END

PROGRAMMING BARCODES

This item specifies the time the scanner will wait for an ACK character from the host following a label transmission.

000 = Infinite timeout

001 - 075 = Timeout in 200-millisecond increments

To configure this feature, scan the “START/END” bar code above to place the unit in Programming Mode, then the “Set ACK NAK Timeout Value,” followed by the three digits (zero padded) from the Alphanumeric table in Appendix C, Alpha-Numeric Pad repre- senting your desired value. Exit programming mode by again scanning the “START/END” barcode above.

DEFAULT SETTING FOR THIS FEATURE: 001 (200 msec)

Set ACK NAK Timeout Value

Product Reference Guide 3-21