Acer M11E manual IDE Secondary Channel Slave, Total Memory, Serial Port, Parallel Port

2.2.10IDE Secondary Channel Slave

This parameter specifies the current configuration of the IDE device connected to the slave port of the secondary IDE channel. For information on how to configure the IDE drives, see section 2.4.3.

2.2.11Total Memory

This parameter specifies the total amount of onboard memory. The memory size is automatically detected by BIOS during the POST. If you install additional memory, the system automatically adjusts this parameter to display the new memory size.

1st Bank/2nd Bank/3rd Bank

The 1st Bank, 2nd Bank, and 3rd Bank parameters indicate the type and size of DRAM installed in DIMM sockets 1, 2, and 3 respectively. The None setting indicates that there is no DRAM installed. For the location of the DIMM sockets, refer to Figure 1-1.

2.2.12Serial Port 1

This parameter shows the serial port 1 address and IRQ setting.

2.2.13Serial Port 2

This parameter shows the serial port 2 address and IRQ setting.

2.2.14Parallel Port

This parameter shows the parallel port address and IRQ setting.

Setup Utility 2-7