Planar UR8450-MX, UR8450-LX, UR8450-3D manual Remote Monitoring Network Setup

Remote Monitoring Network Setup

4Under the DHCP section, select the Yes, use DHCP radio button.

a Change the default DHCP timeout (ten seconds) only if instructed by your network administrator.

b You do not need to fill in anything under the Static (non-DHCP) Network Settings section. However, if you do, these settings will be used in the event that the DHCP attempts to time out.

c Go to step 6.

5Under the DHCP section, select the No, use static settings radio button.

a In the Static (non-DHCP) Network Settings section, enter the IP address provided by your Network Administrator.

b Enter the Network mask, DNS server(s), and Gateway as instructed by the network administrator.

c Go to step 6.

6Scroll to the bottom of the page and click Confirm and apply new network settings to receive the Confirm Network Change page.

7Review the settings to make sure they are correct. Click OK, apply changes now to receive the Applying Network Changes page. This shows the network settings that will be used.

Note: If you have changed the static IP address or changed from static to DHCP setup, you may need to point your browser at the new address.

8You may have to click the Refresh button on your browser to see the new name in the upper left corner of the page.

Planar UltraRes User Manual 65