Electrolux EQBL100AS user manual Electrolux integrated barbecue installation instructions, Diagram

electrolux integrated barbecue installation instructions 7

så 4HEåMINIMUMåWIDTHåOFåTHEåMOUNTINGåSURFACEåISåMM så 4HEåCUTOUTåSIZEåREQUIREDåISåMMåXåMMåSEEå

diagram).

så &ORåROASTINGåHOODåMODELSåTHEREåISåAåSPECIlCåCLEARANCEå required at the back of the barbecue between the splashback and the bench cut-out of 73mm minimum. This is to allow clearance for the hood to open.

warning

så 4HISåAPPLIANCEåREQUIRESåVENTINGå!NåOPENåAREAåASå indicated below must be allowed for. A suitable grille can be fitted if desired. This vent area is to allow air into the enclosure for the correct combustion of gases and for the correct exhausting of the products of combustion. In the case of LPG the gas is heavier than air, this vent in the situation where there may be a leak allows the gas to escape from the enclosure. This vent must be 700mm x 25mm minimum and positioned centrally 135mm below the mounting surface. (see diagram).

bench width 600mm min.

553mm

bench

464mm

553mm

538mm

	wall
	562mm
42mm	bench
177mm
25mm	73mm min.
	from cut-out
	minimum clearance to back wall
	943mm
	1058mm

589mm
538mm	wall	453mm	601mm
211mm
bench	bench
177mm		56mm
		73mm min.
25mm		from cut-out
464mm
	minimum clearance to back wall
925mm
538mm	526mm
	1058mm
	splashback

600mm min.	1025mm cut-out
135mm	1025mm x 502
	cut-out
	502mm
25mm	cut-out
	700mm

600mm min.	1025mm cut-out
135mm	1025mm x 502
	cut-out
25mm	502mm
	cut-out
	700mm

Island style installation	Installation in a bench with splashback
(example shown with barbecue with slimline line)	(example shown with barbecue with roasting hood)