R
Castile Pellet Insert
H. Thermostat Installation
1. A 12 volt AC thermostat is required to operate this pellet appliance. You may use the included wall mount thermostat or purchase an optional programmable thermostat or remote control. The included thermostat is equipped with an adjustable heat anticipator. The current rating is .05 amps. The anticipator needs to be adjusted to the lowest setting available.
2.When mounting a thermostat on a wall, be sure to follow your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accu- rate readings. The thermostat should be mounted on an inside wall and not in direct line with the appliance convection air. Remove any packaging from inside the thermostat before using.
NOTE: If the thermostat is located too close to the appliance, you may need to set the tempera- ture setting slightly higher to maintain the desired temperature in your home.
3.There is a 4 screw terminal block located on the junc- tion box to the left of the power cord inlet. The center 2 screws are for the thermostat wires. The outer 2 are the mounting screws for the terminal block. Figure 23.1.
CAUTION
Shock hazard.
•Do NOT remove grounding prong from plug.
•Plug directly into properly grounded 3 prong receptacle.
•Route cord away from appliance.
•Do NOT route cord under or in front of appli- ance.
| Red Call | Control Box | |
| Light |
|
|
| Fuse |
|
|
|
|
| Power Cord |
|
|
| Outlet |
|
| e | Light |
|
|
| |
|
| Blu | rLight |
|
|
| |
|
|
| mbe |
|
| en/A | |
|
| Gre |
|
Heat Output | Red/ |
| |
|
|
| |
Switch |
|
|
|
Reset Button |
|
| Thermostat |
|
| Block | |
|
|
| |
| Junction Box |
Figure 23.1
August 20, 2009 | Page 23 |