Quadra-Fire 810-02901 G. Optional Log Set Placement Instructions, Four Piece Log Set Installation

R

Castile Pellet Insert

G. Optional Log Set Placement Instructions

CAUTION

Logs are FRAGILE. Use extreme care when handling or cleaning logs.

Four Piece Log Set Installation

1.Open the hinged cast face and open the glass door assembly.

2.Positioning the logs.

Place the right rear log as shown. There is a notch in the bottom of the log for clearance for the thermocou- ple and thermocouple cover (ceramic protection tube).

Figure 22.1

Continue placing the last 3 logs around the fi repot as show in Figures 22.2, 22.3 and 22.4. Be careful not to block the drop tube in the back of the fi rebox where pel- lets feed into the fi repot.

Notch

Thermocouple

Cover

Figure 22.1

Drop Tube

Figure 22.2

NOTE:

Due to the abrasive nature of a pellet appliance fi re, the logs are not covered under warranty. Any placement varia- tion other than shown here can cause excessive heat and shall void the appliance warranty.

Figure 22.3

Figure 22.4

Top Log Installation

Place the log over the fi repot. The charred area on the log is turned toward the back, not the front.

The log will be about 2-1/2 inches (64mm) above the fi repot when in place. It must rest on the 3 logs in a stable position to prevent it from falling into the fi repot. Figure 22.5.

Figure 22.5

Page 22 250-7251G August 20, 2009