Quadra-Fire CASTINS-CWL C. Outside Air Kit Instructions, 2 - Assembled View, Item, Description

R

Castile Pellet Insert

C. Outside Air Kit Instructions D. Zero Clearance Trim Support Instructions

Parts Included in Kit: 1 piece of 2 inch x 3 ft. flex hose, 2

hose clamps, 1 collar assembly, 1 termination cap assem- NOTE: Only for use on small size panels. bly, 1 air intake channel, 1 trim ring, fasteners. NOTE:

Discard air intake channel, it is not used on this appliance.

Tools Needed: Phillips head screwdriver; wire cutters; hole saw or jig saw.

1. Attach collar assembly to appliance. Figure 19.1. Measure distance from fl oor to air vent opening in appliance and mark location on wall.

Figure 19.2 - Assembled View

3.Use saw to cut opening in wall. Cut a 2-1/2 to 3 inch (64-76mm) opening on inside wall and a 3 to 3-1/2

	inch (76-89mm) opening on outside of house.	8
		7
4.	Use hose clamp to secure fl ex pipe to collar assem-
		6
	bly.
5.	Slide trim ring over fl ex pipe and run pipe through
	pre-cut hole in back of appliance and through the
	wall.
6.	Attach hose to outside termination cap with second	5
	hose clamp.	4

7. Secure termination cap to outside surface.

8. Secure trim ring to interior wall.

1

2

CAUTION

Never draw outside combustion air from:

• Wall, floor or ceiling cavity Figure 19.3

•Enclosed space such as an attic or garage

3

Item Description

		1	Front, 3 inch
		2	Front, 5 inch
		3	Cast Ring, Top & Bottom, Interchangeable
		4	Side, 5 inch
		5	Side, 3 inch
		6	Panel Extension, 5 inch
		7	Panel Extension, 3 inch
		8	Panel Extension, Base Plate Only
Air Intake Channel
(Discard)
	Trim Ring	Termination
		Cap Assembly
Hose Clamp	Flex Hose
Collar	Hose Clamp
Assembly

Figure 19.1

August 20, 2009 250-7251G Page 19