R
Castile Pellet Insert
1 Listing and Code Approvals
A. Appliance Certification | E. BTU & Efficiency Specifi cations |
MODEL: | Castile Pellet Insert |
|
|
LABORATORY: | OMNI Test Laboratories, Inc |
|
|
REPORT NO. | |
|
|
TYPE: | Solid Fuel Room Heater/Pellet Fuel |
| Burning Type Insert |
|
|
STANDARD: | ASTM |
| |
| Heater Pellet Fuel Burning Type and |
| (UM) |
|
|
Colorado: | Approved |
|
|
B. Mobile Home Approved
This appliance is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is used.
The structural integrity of the mobile home fl oor, ceiling, and walls must be maintained.
The appliance must be properly grounded to the frame of the mobile home and use only Listed pellet vent Class “L” or “PL” connector pipe.
A
Note: The appliance is also approved for installation into a shop.
C. Glass Specifi cations
This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.
NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the
ASTM E1509-95, ULC S628-93, ULC/ORD-C-1482-
M1990 and (UM) 84-HUD
D. Electrical Rating
115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps
Particulate Emis- | 0.7 grams/hr | |
sions Rating: | ||
| ||
|
| |
*BTU Output: | 8,000 - 30,000 / hr | |
|
| |
Heating Capacity: | up to 1,500 sq. ft. depending | |
| on climate zone | |
|
| |
Hopper Capacity: | 45 lbs | |
|
| |
Fuel: | Wood Pellets or Shelled Corn | |
|
| |
Shipping Weight: | 260 lbs | |
|
|
*BTU output will vary, depending on the brand of fuel you use in your appliance. Consult your
WARNING! Risk of Fire! Hearth & Home Technologies dis- claims any responsibility for, and the warranty and agency listing will be voided by the above actions.
DO NOT:
•Install or operate damaged appliance
•Modify appliance
•Install other than as instructed by Hearth & Home Technologies
•Operate the appliance without fully assembling all components
•Overfi re
•Install any component not approved by Hearth & Home Technologies
•Install parts or components not Listed or approved. Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.
Page 4 | August 20, 2009 |