R
Castile Pellet Insert
7Appliance Set-Up
A. Reversible Top or Rear Flue Adapter | B. Leveling System |
|
Top Vent Installation
1.Release ammo can latches on each side. Figure 18.1.
2.Place the reversible adapter in the correct position for your installation.
3.Make sure BOTH latches are in position before securing them.
Rear Vent Installation
1.Remove the 90o adapter and installation screws from the packaging.
2.Attach the 90o adapter onto the vent adapter, using the 3
screws provided. You will need to
3.Silicone the pipe joints according to the Note below.
NOTE: All pipe must be sealed using welded seam pipe whenever possible. Seal pipe joints with high temperature silicone, minimum rate of 5000F (2600C).
Ammo Can Latches
The back legs are adjustable to allow for customized fi t into zero clearance boxes.
1.Loosen 2 top screws and remove 2 bottom screws.
2.Adjust leg to desired height. Leg can slide up (shorter) or down (longer) to level the insert.
3.Tighten 2 top screws.
4.Drill 2 holes for the bottom 2 screws and
Loosen top 2 screws and remove bottom 2. Adjust leg to desired height.
Figure 18.4
Drill 2 holes and
Figure 18.1 - Top Vent
Figure 18.5
screw
Figure 18.2 - Rear Vent | Figure 18.3 - Rear Vent |
Page 18 | August 20, 2009 |