R
Castile Pellet Insert
E. Igniter Replacement
Igniter Bracket
Thumb Screw | Igniter |
Figure 36.1
a.Shut down the appliance by turning down the thermostat and let the appliance completely cool down. After the appliance has cooled down, unplug it and remove the ash pan.
b.The wire leads to the igniter are connected to the wire harness with 1/4 inch (6mm) male / female spade connectors. These wires will pull forward approximately 4 to 5 inches (102 to 127mm). Disconnect the spade connections and remove the igniter from the chamber. Loosen the thumb screw and slide igniter out.
c.Install new igniter into the chamber and tighten the thumb screw.
d.Remove the right cast side and pull the wire leads back toward the rear of the appliance to
f.
F. Glass Replacement
WARNING
•Glass is 5mm thick high temperature heat- resistant ceramic glass.
•DO NOT REPLACE with any other material.
•Alternate material may shatter and cause injury
a.Open hinged cast face and lift door assembly off from the insert and lay on a fl at surface face down.
b.Using a screwdriver, tap the bottom of the rope retainer rod to push it up out of the hole. The top end of the rod will slide up. Swing the rod toward you from the bottom and remove the rod. Repeat for other side.
c.Remove old glass and replace with new glass.
d.Slide the retainer rod into the top hole fi rst, and then line up the bottom crimped end with the hole in the door. The crimped end must be paralle with the glass in order to insert it into place. Figure 36.2.
Rope Retainer |
Rods |
Slide this |
end in first |
Glass |
Crimped end |
at the bottom |
Crimped end must be |
parallel with the glass |
Figure 36.2
Page 36 | August 20, 2009 |
