R
Castile Pellet Insert
E. Panel Set And Cast Trim Set
Included in Panel Kit: (2) side panels, left and right; (1) panel top; (1) fastener package.
Included in Cast Trim Kit: (2) cast trim legs, left and right; (1) cast trim header; (2) cast trim footers, left and right; (1) fastener package.
Tools Needed: Powered Phillips head screw driver
1.Remove contents from box being careful not to scratch or damage the cast trim pieces.
2.Lay the panel set face down on protective covering to prevent scratching the painted surface.
3.Secure the panels legs to top panel with the screws provided.
4.Now bend the tabs down toward the backside of the panel set,
5on top and 2 on each leg. Leave the panel set face down.
5.Place the corresponding cast trim pieces ( 2 cast trim legs and
1cast trim header) underneath the panel set, also face down.
6.Place washer provided over tab and secure the trim and panel together with screw. Continue for all tabs.
7.Secure cast footers with screws.
8.Remove both left and right cast sides from insert, See Figures 32.1, 32.2 and 32.3 on page 32.
9.Slide panel and trim over the top of the insert into place matching the mounting tabs on the panel with the slots on the insert.
CAUTION
•Do NOT pick up assembled unit by corners.
•It is too heavy and may damage the panels.
•Pick up from center.
F. Panel & Trim Set, Econo
Included in Panel & Trim Kit: (2) corner brackets and set screws; (1) trim set, 3 piece; (2) side panels; (1) top panel;
(4) screws;
Tools Needed: Powered Phillips head screw driver
1.Secure the top panel to the panel sides with the screws provided. Figure 21.3.
2.Assemble the gold trim with the (2) corner brackets provided. Figure 21.4.
3.Slide the assembled trim over the assembled panel set.
4.Slide panel and trim over the top of the insert into place matching the mounting tabs on the panel with the slots on the insert.
Back of Top Panel | |
| Screws |
| Back of Side Panel |
Figure | 21.3 |
|
|
|
|
|
|
|
|
|
|
|
|
|
| 1. Screw panels |
|
|
|
| 2. Bend tabs down |
|
| together | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1. Screw panels
together
2. Bend tabs down
3. Install Cast Trim Header
Mounting tabs on each panel leg to match up with slots on insert.
View of "L" Bracket
installed
Figure 21.4
Figure 21.1
Figure 21.2 - Completed View
of Panel Set & Cast Trim Set
August 20, 2009 | Page 21 |