Brother CM100DM Selecting and Editing the Second Pattern, ECheck the pattern arrangement

■Selecting and Editing the Second Pattern

aTouch the “Add” key in the pattern layout screen.

XThe pattern category selection screen appears.

•Press to cancel the pattern selection, and then select the pattern again.

bSelect the category for the pattern to be cut out.

a

aTouch to return to the previous screen.

cSelect the second pattern to be used.

dEdit the pattern.

After editing is finished, touch the “Set” key.

•For details on the editing functions, see “Pattern Editing Functions” on page 33.

eCheck the pattern arrangement.

The two patterns that will be cut out appear in the pattern layout screen. After checking the arrangement, touch the “OK” key.

•From this screen, an individual pattern can be edited, moved or deleted. For details on the functions that can be used in the pattern layout screen, see “Layout Editing Functions” on page 35.

•By using the auto layout function, the arrangement of the patterns can easily be adjusted. For details, see “Auto Layout Functions” on page 38.

XThe draw/cut selection screen appears.

Note

•Depending on the pattern type and material to be cut, the patterns may not be cleanly cut if their spacing is too small. In that case, rearrange the patterns to separate them.

Memo

•To move a pattern within the cutting/drawing area, touch the pattern on the screen and drag it to the desired position.

•To delete a pattern from the arrangement, select the pattern in the layout editing screen, and then use the function for deleting.

X Touch in the pattern layout screen.

26