Panasonic KX-FL501NZ Error Messages, Reports, Communication message Error Cause & solution Code

Error Messages

Reports!

If your unit cannot send a fax, check the following: —the number you dialed is correct,

—the other party’s machine is a facsimile.

If the problem remains, correct it by following the communication message printed on the sending and journal reports (p. 37).

Communication message	Error	Cause & solution
	code
COMMUNICATION ERROR	40–42	●
		A transmission or reception error occurred. Try
	46–52	again or check with the other party.
	58, 65
	68, 72
	FF
	43	●
		A line problem occurred. Connect the telephone
	44	line cord to a different jack and try again.
		An overseas transmission error occurred. Try using
		●
		the overseas mode of feature #23 (p. 59).
DOCUMENT JAMMED	—	The document is jammed. Remove the jammed
		●
		document (p. 74).
ERROR-NOT YOUR UNIT	54	A transmission or reception error occurred because
		●
	59	of a problem with the other party’s fax machine.
	70	Check with the other party.
MEMORY FULL	—	●
		The document was not received due to memory
		being full.
NO DOCUMENT	—	●
		The document was not fed into the unit properly.
		Reinsert the document and try again.
OTHER FAX NOT RESPOND	—	●
		The other party’s fax machine is busy or has run
		out of recording paper. Try again.
		●
		The document was not fed properly. Reinsert the
		document and try again.
		●
		The other party’s fax machine rings too many
		times. Send the fax manually – dial the number,
		confirm the fax tone, and press FAX START .
		●
		The other party’s machine is not a facsimile. Check
		with the other party.
		●
		The number you dialled is not in service.
PRESSED THE STOP KEY	—	● STOP was pressed and fax communication was
		cancelled.

THE COVER WAS OPENED

—

●The front cover was opened. Close it and try again.

OK

—

●Fax communication was successful.

63