Linksys EG0801SK manual Instant Gigabit Series

Page 40

Instant Gigabit Series

PCI (Peripheral Component Interconnect) - A peripheral bus commonly used in PCs, Macintoshes and workstations. It was designed primarily by Intel and first appeared on PCs in late 1993. PCI provides a high-speed data path between the CPU and peripheral devices (video, disk, network, etc.). There are typically three or four PCI slots on the motherboard. In a Pentium PC, there is generally a mix of PCI and ISA slots or PCI and EISA slots. Early on, the PCI bus was known as a "local bus."

PCI provides "plug and play" capability, automatically configuring the PCI cards at startup. When PCI is used with the ISA bus, the only thing that is gen- erally required is to indicate in the CMOS memory which IRQs are already in use by ISA cards. PCI takes care of the rest.

PCI allows IRQs to be shared, which helps to solve the problem of limited IRQs available on a PC. For example, if there were only one IRQ left over after ISA devices were given their required IRQs, all PCI devices could share it. In a PCI- only machine, there cannot be insufficient IRQs, as all can be shared.

Port - A pathway into and out of the computer or a network device such as a switch or router. For example, the serial and parallel ports on a personal com- puter are external sockets for plugging in communications lines, modems and printers.

PPPoE (Point to Point Protocol over Ethernet) - A method used mostly by DSL providers for connecting personal computers to a broadband modem for Internet access. It is similar to how a dial-up connection works but at higher speeds and quicker access.

RJ-11(Registered Jack-11) - A telephone connector that holds up to six wires. The RJ-11 the common connector used to plug a telephone into a wall.

RJ-45(Registered Jack-45) - A connector similar to a telephone connector that holds up to eight wires, used for connecting Ethernet devices.

Static IP Address - A permanent IP address that is assigned to a node in an IP or a TCP/IP network.

Static Routing - Forwarding data in a network via a fixed path. Static routing cannot adjust to changing line conditions as can dynamic routing.

Storage - The semi-permanent or permanent holding place for digital data.

EtherFast® 10/100/1000 8+1 Workgroup GigaSwitch Starter Kit

STP (Shielded Twisted Pair) - Telephone wire that is wrapped in a metal sheath to eliminate external interference.

Subnet Mask - The method used for splitting IP networks into a series of sub- groups, or subnets. The mask is a binary pattern that is matched up with the IP address to turn part of the host ID address field into a field for subnets.

TCP (Transmission Control Protocol) - A method (protocol) used along with the Internet Protocol (Internet Protocol) to send data in the form of message units between computers over the Internet. While IP takes care of handling the actual delivery of the data, TCP takes care of keeping track of the individual units of data (called packet) that a message is divided into for efficient routing through the Internet.

TCP/IP - Transmission Control Protocol/Internet Protocol (TCP/IP) is the basic communication language or protocol of the Internet. It can also be used as a communications protocol in a private network (either an intranet or an extranet). When you are set up with direct access to the Internet, your comput- er is provided with a copy of the TCP/IP program just as every other computer that you may send messages to or get information from also has a copy of TCP/IP.

TFTP (Trivial File Transfer Protocol) - A version of the TCP/IP FTP protocol that has no directory or password capability.

Throughput - The amount of data moved successfully from one place to another in a given time period.

TX Rate - Transmission Rate.

UDP (User Datagram Protocol) - A communications method (protocol) that offers a limited amount of service when messages are exchanged between com- puters in a network that uses the Internet Protocol (IP). UDP is an alternative to the Transmission Control Protocol (TCP) and, together with IP, is sometimes referred to as UDP/IP. Like the Transmission Control Protocol, UDP uses the Internet Protocol to actually get a data unit (called a datagram) from one com- puter to another. Unlike TCP, however, UDP does not provide the service of dividing a message into packets (datagrams) and reassembling it at the other end. Specifically, UDP doesn't provide sequencing of the packets that the data arrives in. This means that the application program that uses UDP must be able to make sure that the entire message has arrived and is in the right order.

73

74

Page 39 Page 41
Image 40
Page 39 Page 41
Contents EtherFast 10/100/1000 +1 Workgroup GigaSwitch Starter Kit Copyright & Trademarks Contents Your EtherFast 10/100/1000 8+1 Workgroup Gigaswitch FeaturesPackage Contents Introduction10/100/1000 Workgroup GigaSwitch’s Rear Panel GigaSwitchPower 10/100/1000 Workgroup GigaSwitch’s Front PanelSwitches Versus Hubs Planning Your NetworkLEDs RJ-45 PortWhere to Install the Instant Gigabit Network Adapter Installing the Network Card & Cabling Installing The Instant Gigabit Network AdapterRemove your computers outside cover Installing The Workgroup Gigaswitch Connecting Computers To Your SwitchUplinking to Other Switches and Hubs Connecting Your Hardware Together and Booting UpTips on Switching Your Network Installing the Drivers for WindowsVersion a Version B also known as OSR2 Installing the Driver in Windows 95 Version B Installing the Network Adapter’s Driver Instant Gigabit Series Installing the Drivers for Windows Millennium Installing the Network Adapter’s DriversInstant Gigabit Series Windows NT 4.0 Installation & Setup Installing NT Networking and the Network Adapter Driver Instant Gigabit Series Page Instant Gigabit Series \i386 Installing the Drivers for Windows Completing the Found New Hardware Wizard dialog box will Advanced Properties Configuring the Adapter for Windows 95, 98, and Millennium Configuring The Instant Gigabit Network AdapterConfiguration tab Click on Appendix Sharing Your Files and PrintersOverview Enabling File SharingInstalling the Driver in Windows 95 Version a Enabling Printer SharingNetWare portion of your Windows setup is complete Starting Over in Windows 95, 98, or MillenniumInstant Gigabit Series Starting Over in Windows Manually Installing the Network Components in Windows Click on Start, Settings, then Control Panel IPX/SPX-compatible ProtocolNetBEUI Client for Microsoft NetworksMotherboard Support Installing and Configuring Wake-On-LANAbout Plug-and-Play PCI Technology Linux, Open Source and Beta Operating Systems TroubleshootingTwisted-Pair Cabling You receive Dhcp Errors in Windows Network Neighborhood is EmptyGlossary Instant Gigabit Series Instant Gigabit Series Instant Gigabit Series Specifications Specifications for EG1032Specifications for EG0801W EnvironmentalWarranty Information Tech Support and RMA Issues FaxContact Information InformationT p / / w w w. l i n k s y s . c o m

EG0801SK specifications

The Linksys EG0801SK is an advanced 8-port Ethernet switch designed to provide high-performance networking solutions for small to medium-sized enterprises, home offices, or any environment requiring reliable connectivity. Combining speed, performance, and versatility, this switch is an essential component for users looking to expand their local network efficiently.

The EG0801SK operates on a non-blocking architecture, ensuring that each port can handle consistent data transfer rates without interference. This is crucial for environments where multiple devices are connected simultaneously, as it guarantees minimal latency and efficient bandwidth utilization. With support for 10/100/1000 Mbps speeds, the switch is fully compatible with various devices, including computers, printers, and IP cameras, facilitating smooth communication across the network.

One of the standout features of the Linksys EG0801SK is its switch fabric that offers a high throughput. This means that it can handle burst traffic without any drops, ensuring that data-heavy applications can run uninterrupted. With Auto-MDI/MDIX support, users need not worry about the type of cables used; the switch automatically detects and adjusts, simplifying installation processes and reducing setup time.

In addition to its performance capabilities, the EG0801SK incorporates energy-efficient technologies that help reduce power consumption. The device uses energy-saving features such as "Green Ethernet," which adjusts power usage according to the number of connected devices and their respective activity levels. This makes the EG0801SK an environmentally friendly option, appealing to businesses looking to reduce their carbon footprint.

The sleek design of the Linksys EG0801SK allows it to fit seamlessly into any office environment, whether mounted on a wall, placed on a desk, or incorporated into a server rack. The switch is also equipped with LEDs for port status monitoring, providing users with real-time insights into connectivity and operation status.

In conclusion, the Linksys EG0801SK is a robust, feature-rich Ethernet switch that stands out due to its performance, reliability, and energy efficiency. It is designed to meet the demands of today's networking needs while ensuring ease of use and maintenance, making it an ideal choice for any networking environment.
Top Page Image Contents