8e6 Technologies TAR 1.0 quick start System Status Screen, Log Off, Disconnect the Peripherals

Page 32

System Status Screen

The System Status screen contains the following information:

•LAN1 (eth0) interface for web access and R3000 communications: LAN1 (eth0) IP address and netmask specified in screen 3 (Configure Network Interface), and current status (“Active” or “Inactive”)

•LAN2 (eth1) interface for bandwidth monitoring: LAN2 (eth1) IP address and netmask specified in screen 4 (Configure Network Interface), and current status

(“Active” or “Inactive”)

•Default gateway IP address specified in screen 5 (Configure default gateway)

•Configure host name specified in screen 7 (Configure Host Name)

•DNS server IP address(es) specified in screen 6 (Configure Domain Name Servers)

•Current status of the Threat Analysis Reporter

•Current Version of the Threat Analysis Reporter software

NOTE: Modifications can be made at any time by returning to the specific screen of the wizard.

Log Off, Disconnect the Peripherals

A.After completing the wizard setup procedures, return to the System Configuration screen and press 9 to log out.

B.Disconnect the peripherals from the Threat Analysis Reporter.

28	8e6 Threat Analysis Reporter Quick Start Guide

Image 32

Contents Guide 8e6 Threat Analysis Reporter Quick Start Guide Contents 8e 6 Threat Analysis Reporter Quick Start Guide Threat Analysis Reporter Introduction About this Document Conventions Used in this Document8e6 Taiwan Procedures8e6 Corporate Headquarters USA Unpack the Unit from the Carton Rack Setup Suggestions Install the Chassis RailsRack Mount the S or MSA Server Rack Mount InstructionsInstall the Rack Rails Install the Server into the RackInstalling the Server into a Telco Rack Install the H Server Bezel 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide Rack Mount the H Server Install the Inner RailsInstall the Outer Rails Install the Server into the Rack Installing the Server into a Telco Rack Initial Setup Procedures Link the Workstation to the Threat Analysis Reporter Monitor and Keyboard SetupSerial Console Setup HyperTerminal Setup Procedures 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide Step-by-Step Initial Setup Procedures Login screen, password prompts#s3tup#r3k Configure Network Interface screen 8e6 Threat Analysis Reporter Quick Start Guide Configure default gateway screen Configure Domain Name Servers screenConfigure Host Name screen Time zone regional configuration screen Configure Wizard user screen Setup Wizard Confirmation screen Administration menuSystem Status Screen Log Off, Disconnect the PeripheralsPhysically Connect the Unit to the Network Bandwidth ManagementWizard Setup Procedures Access the Threat Analysis Reporter Administrator ConsoleLog in to the Threat Analysis Reporter Administrator Console Register administrator 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide Register R3000 & ER R30008e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide 8e 6 Threat Analysis Reporter Quick Start Guide Register Gauges Specify Gauge Groups to be MonitoredView, Edit Gauge Components Server Settings Conclusion Physical Specifications Internal Product SpecificationsHardware Component Specifications FCCMSA Front Panel LED Indicators, Buttons Diagrams and DescriptionsLED Indicators and Buttons LED Indicator KeyUnpack the Ethernet Tap Unit from the Box Preliminary Setup ProceduresOther Required Installation Items Install the Ethernet Tap Unit Ports in front panel of NetOptics 10/100BaseT Tap Tap Installation