8e6 Technologies TAR 1.0 quick start 8e6 Threat Analysis Reporter Quick Start Guide

Page 41

•To modify the IP address and Server Name for the R3000 server, click the [+] Add tab to re-open the R3000 Information dialog box, and edit information as necessary. Click OK to close the dialog box and to display the modified informa- tion in the list box.

•To designate an R3000 as the Master R3000 server, click the entry for the R3000 server in the list box to highlight it, and then click the Set as Master tab to display “Master” in the Master column for that entry in the list box.

•To remove the entry for the R3000 server from the list box, click the [-] Remove tab.

F.Specify the User Authentication method to be used for monitoring activity on the Threat Analysis Reporter server: “LDAP” or “IP group”:

ER:

Respond to the question “Do you have an Enterprise Reporter?” by clicking the radio button corresponding to either “Yes” or “No”.

•If “No” was selected, click NEXT > at the bottom right of the screen to go to Step 3.

•If “Yes” was selected, the IP address and Server Name fields display in place of the radio buttons. The < Back button displays above the Server Name field.

8e6 Threat Analysis Reporter Quick Start Guide

37

Image 41

Contents Guide 8e6 Threat Analysis Reporter Quick Start Guide Contents 8e 6 Threat Analysis Reporter Quick Start Guide Threat Analysis Reporter Introduction Conventions Used in this Document About this Document8e6 Taiwan Procedures8e6 Corporate Headquarters USA Unpack the Unit from the Carton Install the Chassis Rails Rack Setup SuggestionsRack Mount the S or MSA Server Rack Mount InstructionsInstall the Server into the Rack Install the Rack RailsInstalling the Server into a Telco Rack Install the H Server Bezel 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide Rack Mount the H Server Install the Inner RailsInstall the Outer Rails Install the Server into the Rack Installing the Server into a Telco Rack Initial Setup Procedures Link the Workstation to the Threat Analysis Reporter Monitor and Keyboard SetupSerial Console Setup HyperTerminal Setup Procedures 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide Login screen, password prompts Step-by-Step Initial Setup Procedures#s3tup#r3k Configure Network Interface screen 8e6 Threat Analysis Reporter Quick Start Guide Configure Domain Name Servers screen Configure default gateway screenConfigure Host Name screen Time zone regional configuration screen Configure Wizard user screen Administration menu Setup Wizard Confirmation screenLog Off, Disconnect the Peripherals System Status ScreenBandwidth Management Physically Connect the Unit to the NetworkAccess the Threat Analysis Reporter Administrator Console Wizard Setup ProceduresLog in to the Threat Analysis Reporter Administrator Console Register administrator 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide R3000 Register R3000 & ER8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide 8e 6 Threat Analysis Reporter Quick Start Guide Specify Gauge Groups to be Monitored Register GaugesView, Edit Gauge Components Server Settings Conclusion Internal Product Specifications Physical SpecificationsFCC Hardware Component SpecificationsDiagrams and Descriptions MSA Front Panel LED Indicators, ButtonsLED Indicators and Buttons LED Indicator KeyUnpack the Ethernet Tap Unit from the Box Preliminary Setup ProceduresOther Required Installation Items Install the Ethernet Tap Unit Ports in front panel of NetOptics 10/100BaseT Tap Tap Installation