5Installing NetWare Drivers
Installing the NetWare Driver Using INETCFG
To install the NetWare driver:
1Copy the MSM.NLM, ETHERTSM.NLM, and NBI.NLM files from the NWSERVER directory on the EtherCD to the system directory; or use the latest service pack from Novell.
NOTE: Copy the NLM files only if the versions existing on the server are older than the versions supplied on the EtherCD.
The NLM file location is typically in the SYS:SYSTEM directory. You need a NetWare client system to copy the NLM files to the server.
2Insert installation diskette 2 in drive A.
3At the server prompt, enter: load inetcfg
The Internetworking Configuration screen appears.
4In the displayed menu, select Boards, and then press Enter.
5Press Insert.
A list of currently installed drivers appears.
6Press Insert again.
The New Driver dialog box appears.
7Enter the directory: a:\nwserver\3c99x.lan
An updated list of installed drivers appears.
8Select 3C99x, and then press Enter.
You are prompted to name the NIC, for example: 3c99x_1.
9Type the name of the NIC and press Enter.
You are prompted for the slot number. For information on how to verify the slot number, see “Verifying the PCI Slot Number” on page 43.
10Enter the slot number, and then press Enter.
11Press Esc, Enter (to save), and then Esc.
The Internetworking Configuration screen appears.
12Select Bindings, and then press Enter.
The configured protocols for installed NICs appears. (This list is empty if no protocols are currently bound to the NIC.)
13Press Insert.
The Select From the List of Configured Protocols screen appears.
For NetWare 5.x or 6x:
■The default To a Network Interface is selected. Press Enter. The Select a Configured Network Interface screen appears.
■Select the board. For example, enter: 3c99x_1, and then press Enter.
14When prompted, enter the network number, and then press Enter.
15In the Frame Type field, press Enter to display a list of frames, choose a frame, and press Enter.
42