ADIC 7000DLT, 4000 Unpacking and Inspecting, Installing the Host Adapter

Page 35

Overview

This chapter explains the steps necessary to install and test your 4000/7000DLT Series. It also provides an information symbol for each event that you should verify as correct before continuing.

Unpacking and Inspecting

Unpack all items from the carton.

None of the components should have any damage.

Save the packing materials in case you need to move or ship the system in the future. You must ship the unit in the original or equivalent packing materials or your warranty may be invalidated.

Installing the Host Adapter

If your host computer does not have native SCSI capability and the host adapter you are using is not installed, please install it. Refer to the manual that came with your host adapter for specific directions.

Connecting the Interface Cable

Note

The bail (or other) locks at the ends of the SCSI cable must be securely fastened to insure communications between the 4000/7000DLT Series and the host computer.

Attach an interface cable between the host adapter and your 4000/7000DLT Series. The kind of cable you need depends on the kind of SCSI bus connector on your host adapter. The 4000/7000DLT Series has two SCSI device connectors on the rear panel. It does not matter which connector you use.

Make sure that the SCSI cable between the host adapter and the 4000/7000DLT Series is secure and the connections are fastened correctly.

Overview 4-3

Image 35
Contents Installation and Operation Guide Copyright 1999 all rights reserved Contents Operation and Maintenance SafetyInstallation Specification Troubleshooting and DiagnosticIndex Drive ConfigurationRegulatory Notices Figures Viii Figures Tables Tables Introduction Introduction 62-0162-01 Organization OverviewIntended Audience Associated Documents Explanation of Symbols and NotesDescription Description 62-0162-01 Model DLTTape DLTTape Iiixt Model Drive Model Front Panel Controls and IndicatorsModel Sustained Maximum Description 24000DLT Front Panel Write Protected Control or Connector Purpose Rear Panel Controls and ConnectorsColor Length ModelCartridge Model Tape Scsi Host Adapter Other RequirementsCartridge Requirements Scsi Interface CableApplication Software Additional ItemsDescription 62-0162-01 Safety Safety 62-0162-01 Signal Word Definition Consequence Safety ConventionsSymbol Precautions Precautions Safety 62-0162-01 Installation Installation 62-0162-01 Unpacking and Inspecting Installing the Host AdapterConnecting the Interface Cable Aisy C hained Connecting More than One 4000/ 7000DLT SeriesSetting the Scsi ID Check the Scsi Bus Termination Installing the Backup Software Connecting Power and Turning OnInstallation 62-0162-01 Operation Maintenance Operation and Maintenance 62-0162-01 Power-on Self-Test Drive Status Drive State LED Indicator Displays and Drive ActionsDrive State LCD MessagesLabel Color State Operating Condition Right Indicator Panel LEDDrive Operating Conditions Left Indicator Panel LED LCD Message Drive Operation LCD Messages 4Drive Operation LCD Messages 4Drive Operation LCD Messages Lift up on the Cartridge Insert/Release Handle Loading the Data CartridgeTape in Use Data ProtectionState Meaning Right Indicator PanelRemoving the Data Cartridge Push the Cartridge Insert/Release Handle closed Cleaning the Tape HeadIt means You should Cleaning Tape LEDCleaning Cycle LCD Messages Cleaning the Enclosure Troubleshooting Diagnostic Troubleshooting and Diagnostic 62-0162-01 Then You should Troubleshooting ChartProblem Chart Use Cleaning Tape LED Why the Use Cleaning Tape LED Gets Turned on High Humidity Troubleshooting and Diagnostic 62-0162-01 Specification Specification Table A-1 General SpecificationTable A-1 Drive Configuration Drive Configuration DLT4000 Drives Drive Dependent ConfigurationScsi Bus Parity DLT7000 Drive Figure B-3DLT7000 Tape Drive Connectors Right SideFigure B-5DLT4000 Tape Drive Connectors right side Scsi Bus Termination and Terminator PowerThen You Should DLT7000 Drives Figure B-7DLT7000 Tape Drive Connectors right sideDrive Configuration Regulatory Regulatory Notices Shielded Cables FCC Notices U.S. OnlyIC Notice Canada Only Product TypeCE Notice EN 55022 Compliance Czech Republic OnlyVcci Notices Japan Only GB format IndexMotion Messages Index in-9 In-10 Index 62-0162-01